S Rev /#
Cedar Stacking Garden
This terraced garden creates a focal point in your landscape, while providing plenty of space for growing vegetables, herbs and
flowers. The raised beds are made out of rot-resistant cedar and sturdy aluminum corners, making them durable and long-lasting.
Parts List Tools needed
() ’ Wood Boards Screw gun with Phillips bit
() ’ Wood Boards Tape Measure
() ’ Wood Boards Rubber Mallet
() Corners
() ” Corner Stake
() ” Corner Stakes
() ” Flat Supports
() ” Flat Supports
Screws
() Corner Caps
Assembly
Step 1. Choose a level area for your raised bed. If
you are installing it on a lawn, we recommend
removing the sod and loosening the soil with
a shovel or spade to a depth of ".
Step 2. Take of the ’ Wood Boards and of the
’ Wood Boards and lay them on their sides to form a rectangular bed. Seat the ends of the Boards
into four of the Aluminum Corners (Figure ). Make sure the Boards are fully seated and level with
the bottom of the Corners. Use your screw gun to insert Screws into the holes in the Corners.
Step 3. Repeat Step to assemble the ' x ', ' x ' and ' x ' raised beds (Figure ).
Step 4. Sit the ' x ' raised bed on top of the ' x ' Raised Bed, as shown in Figure . Place the ' x '
Raised Bed on top of the ' x ' bed.
Step 5. Make sure the Corners of the Raised Beds are lined up as shown in Figure and slide the ”
Corner Stake through the three Corners stacked on top of each other. Slide
the ” Corner Stakes into the two sets of two Corners stacked on top of
each other. NOTE: If necessary, use a rubber mallet to tap the Corner Stakes
into place.
Step 6. Starting with the ' x ' Bed, use a Tape Measure to mark " in on
both sides of the ' Board that sits directly on top of the ' x ' Raised Bed
(Figure ). Place a " Flat Support at each marked spot. Make sure the
Supports are straight, and use your screw gun to attach them to the Raised
Beds.
Step 7. Use a Tape Measure to mark " in on the ' Board that has both the
' x ' and ' x ' bed underneath it (Figure ). Place the remaining " Flat
Support at the marked spot and make sure it is straight before attaching it to
the Raised Beds.
Step 8. Measure " in on the same ' Wood Board that you just attached the
" Flat Support to (Figure ). Place a " Flat Support at the marked spot.
Make sure it is straight, then use your screw gun to attach it to the Raised
Beds.
over please
2' x 4' Raised Bed
2' x 2' Raised Bed
4' x 4'
Raised Bed
4' x 6' Raised Bed
Figure 1
Slide the 20” Corner Stake
through the 3 Corners stacked
on top of each other.
Slide a 13” Corner
Stake through the
2 stacked Corners.
Slide a 13” Corner Stake
through the 2 stacked Corners.
21" Flat
Supports
2' x 4'
Raised Bed
4' x 4'
Raised Bed
4' x 6'
Raised Bed
16" 16" 16"
Figure 3
Figure 2
2' x 4'
Raised Bed
4' x 4'
Raised Bed
4' x 6'
Raised Bed
21" Flat Support
13" Flat Support
12"
12"
Figure 4
