Gasmate BQ1011P User manual

Professional Bench Module
Model No. BQ1014P
Professional Drawer Module
Model No. BQ1021P
Professional Sink & Fridge Module
Model No. BQ1013GFP
Professional 6 Burner Premium BBQ
Model No. BQ1011P
Professional Fold Down
Side Shelves
(pack of 2)
Model No. BA1018
(shown on BBQ
sold separately)
Professional 450Corner Module
Model No. BQ1012P
Gasmate®is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au
Aber Holdings Ltd - N.Z www.gasmate.co.nz
PROFESSIONAL MODULAR SERIES
Important: Retain these instructions for future use.
03503 11/16
TOOLS REQUIRED
Standard Phillips-head screw driver.
IMPORTANT: Remove all packing and transit protection
before assembly.
CAUTION: Ensure no packing material is left in BBQ
before lighting.
Reference Models ONLY
Please refer to the diagrams for completed assembly of modules

Use 2 screws, 2 rubber washers and 2 washers as shown. There is no need for nuts as the cabinets have captive nuts
inside the panels.
Use 2 screws, 2 rubber washers and 2 washers as shown to connect a 45 degrees corner section.

Demonstrating how to connect another 45 degrees corner section.
Use 2 screws, 2 rubber washers and 2 washers as shown to connect the final module.

Finished Outdoor Kitchen Gas Grill (For Reference Only)
Models purchased may differ from those shown.

Top Panel
Front
Pillar
Rear
Pillar (2)
Base Panel
Castors (3)
Washers (12)
M6 x 12mm Screws (12)
6
ASSEMBLY INSTRUCTIONS - 450Corner Module.
Model No. BQ1012P Corner
ASSEMBLY
1. Attach the 3 castors to the base panel. 2. Attach the front pillar to the base
using 2 screws.
3. Attach the other two pillars
to the base panel using 4
screws.
4. Attach the top panel using
6 screws and washers.
PARTS LIST

ASSEMBLY INSTRUCTIONS - Side Shelves. Model No. BA1018P
1. Pre-assemble the top two screws, leaving them loose.
2. Hang the side shelf onto these 2 screws.
3. Insert two screws into the lower holes and tighten.
Four (4) M6X15 Screws
and washers
Side shelves can be folded down by first lifting up and then rotating down as shown.