
6 7
GAS SAFETY
ONLY USE THE HOSE ASSEMBLY TYPE
27 SPECIFIED BY THE MANUFACTURER
ON THIS APPLIANCE. REPLACEMENT
HOSE ASSEMBLIES MUST BE THOSE
SPECIFIED BY THE MANUFACTURER.
Thisisalimitativeconguredappliancefor
LPG gas. Do not attempt to use other type gas
supplyunlesstheovenhasbeenrecongured
for other gas use.
The installation of this appliance must conform
to local codes.
Make sure that both gas cylinder and gas
hose do not come in contact with any high
temperature parts.
WARNING
Prior to use, check the oven and burner and
venturi for blockages (eg, food residue or insect
nests-Wasps,BeesorAnts.)Ifaninsectnest
is found they can be dangerous and must be
cleaned out thoroughly. Please refer to the
cleaning and maintenance sections at the end
of this chapter for guidance on how to do this.
Should the appliance go out for any reason, turn
othecontrolknobandthecylindergasvalve.
Wait5minutesbeforeattemptingtorelightthe
appliance.
Somefoodsproduceammablefatsandjuices.
AttendtoanoperatingPizzaOvenatalltimes-
it should never be left unattended. Damage
causedbyfatandgreaseresisnotcovered
bywarranty.Ifagreaseorfatreshouldoccur,
immediatelyturnoburnerknobandthegas
cylindervalveuntilthereisout.Removeall
food from the appliance.
Aleaktestmustbecarriedoutpriortousingthe
applianceforthersttimeandwheneverthe
gascylinderisrelledorwheneverthegashose
and regulator have been disconnected from the
gascylinderorappliance.Applysoapywaterto
the entire hose assembly type 27, including the
gas bottle’s valve and regulator, using a spray
bottle or sponge. Pressurise the system without
turning on your Pizza Oven (i.e. slowly open
the gas supply on your gas bottle). If you see
bubbles or smell rotten eggs, you have a leak.
Dishwashing liquid/soap is formulated to make
lots of bubbles and ideal for mixing with water
to make your soapy liquid for this leak test.
Please take a moment to review all of the safety
requirements before operating the appliance
when using gas.
• Donotdisconnectanygasttingswhilethe
appliance is operating
• Checkallgashoselinesandconnections
for cuts, cracks and other damage. Gas
cylinders must not be stored in enclosed
areas
• Keepthefuelsupplyhoseawayfromheated
surfaces or direct sunlight. Do not use any
additionalammablesubstancewhilst
operating with gas
• Donottouch!ThePizzaOvencanget
extremelyhotwheninoperation.Besureto
wear protective gloves
• Keepthecylinderoutdoorsinit’supright
position
• Donotconnectmultiplegascanistersto
Pizza Oven or store a spare within the same
vicinity
• OnlyusearegulatorcertiedtoAS4621and
ahoseassemblytype27certiedtoAS/NZS
1869, between the gas cylinder and the pizza
oven
• Donotpositionthegascanisterunderthe
oven.Neveruseanakedametocheck
forgasleaks.Donotusenaturalgas!Itcan
damage the oven
• Maximumlengthofhosecannotexceed
1.5m
• Nationalrequirementsstatehowoftento
replace the hose
• Neverllthecylinderbeyond80percentfull
• Makesuretheexibletubeisnottwisting
when the appliance is in operation.
CONNECTING TO GAS
Step 1: Check that the gas you have is Propane
LPG.
IMPORTANT! The gas cylinder used must have
a safety collar to protect the valve assembly.
Do no use a cylinder that is rusty, dented, has a
damaged valve or has past any expiry dates.
Note:OnlycertiedgasregulatorstoAS4621
andcertiedhoseassembliestoAS/NZS1869,
may be used.
Note: The length of the gas supply hose must
not exceed 1.5m.
IMPORTANT!
Keep the gas hose away from hot surfaces and
protectfromdrippinggrease.Avoidunnecessary
twisting of hose. Visually inspect the hose prior
to each use for cracks, excessive wear or other
damage. Replace the hose if necessary. It is
recommended that you replace the hose every
5 years.
WARNING
Donotconnecttheregulatortothecylinderrst!
WARNING
If at any point you smell gas:
• Shutothegasatthecylinder
• Rotate the control knob on your Pizza oven
totheoposition(clockwise),whichshould
extinguishanyopenames
• If odour continues, move away from the pizza
oven and gas supply, then contact your local
rebrigadeforfurtherassistance.
Step 2: Connect the regulator to the gas cylinder,
following the instructions for your regulator
accordingly. Don’t force the regulator as this could
damagethegascylinderorregulatortting.
CONNECTING THE LIQUID PROPANE
CYLINDER
To connect the Liquid Propane gas supply
cylinder: The cylinder valve should be in the
“OFF”position.Ifnot,turnthevalveclockwise
until it stops. Make sure the cylinder valve
has the proper connections per LCC27. Make
suretheburnervalveisinthe“OFF”position.
Inspect the valve connections, port and regulator
assembly to the valve, use your hand to tighten
thenutclockwiseuntilitstops.Useofawrench
could damage the quick coupling nut and result
in a hazardous situation, open the cylinder valve
fully by turning the valve counter-clockwise.
Beforelightingtheoven,useasoapandwater
solution to check all the connections for leaks. If
aleakisfound,turnthecylindervalve“OFF”and
do not use the oven until a local Liquid Propane
dealer can make repairs.
WARNING!
DO NOT USE AN ADAPTOR AT THE
CYLINDER CONNECTION
1. Do not store a spare LP gas cylinder under
or near this appliance
2. Neverllthecylinderbeyond80percentfull
3. If the information in item 1&2 is not followed
exactly,arecausingdeathorseriousinjury
may occur.
CAUTION:Placedustcaponcylindervalve
outlet whenever the cylinder is not in use. Only
install the type of dust cap on the cylinder valve
outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in
leakage of propane.
This appliance has been supplied withe the new
safer gas cylinder connection Safe Lok LCC27 Type
27 regulator and hose connection. This connection
will only connect to a 4kg or 9kg gas cylinder with
an LCC27 Type 27 cylinder valve. This connection
will NOT connect (screw) to the old type 21 POL gas
cylinder valve.
LCC27 Regulator
& Hose
LCC27 Gas
Cylinder
(Cylinder
Not Included)
LCC27 Cylinder
Connection Device
Minimum: 24” (600mm)
Only use the appliance with
gas cylinder that does not
exceed600mminheightand
300mmindiameter.