GCC Technologies EXPERT 24 LX User manual

Firmware model changing on GCC cutting plotter
2 in 1 main board
Can only way by USB port.
QC Loader file choose rule
QC Loader file
M/B base LCM LCM NO LCM
Puma II, Expert
24/LX, Bengal V
Puma II Plus/Puma
III, Expert Pro V V
Jaguar II/III/IV,
Vogue V V
LCM TYPE NO LCM TYPE
For example:
Jaguar IV (LCM) to Puma II (NO LCM).
Step1.
Connector PC with Jaguar IV by USB cable, on Jaguar IV press “Pause” key (hold) then turn on
nachine entrance to USB update procedure.

Step2.
Use Uploader Browse the file “QCLoader_LCM”, select USB then press Start.
(If NO LCM machine, please Browse “QCLoader_NO_LCM” in this step)
Step3.
After file translation finished, make sure no any action on panel please wait 3 minute later then turn
off machine.
Step4.
Turn on machine if going to USB update procedure directly mean Step2 is successed. Then turn off
machine.
If no, please re-do Step1~ Step3.
Step5.
Disassemble main board from JIV then install on PII.
Step6.
Connector PC with PII by USB cable, on PII press “Pause” key (hold) then turn on nachine entrance to
USB update procedure.
Step7.
Use Uploader Browse the PII latest firmware, select USB then press Start.
Step8.
After firmware translation finished, make sure no any action on panel please wait 3 minute later then
turn off machine.
Step9.
Turn on machine if work to normaly status means successed.
If going to USB update procedure, please re-do Step6~ Step8.