Geberit AquaClean 4000 User manual

Cleaning instructions for end users
Permissible cleaning agents and
cleaning equipment
Non-permissible cleaning agents and
cleaning equipment
Geberit AquaClean 4000
965.475.00.0 (01)
Quick guide

Geberit AquaClean 4000 integrated control panel
<Water heater function> ON/OFF/economy mode
Pressing the button switches the water heater function on, off or to
economy mode.
<Shower>, start and stop
Press the button: The spray arm moves into position and the shower
procedure starts. The shower automatically stops after 20s.
You can stop the shower before this by pressing the <shower> button.
Press the button again: The shower stops.
<Spray intensity>
Press <+> or <-> during the shower procedure to change the spray
intensity.
There are 5 spray intensity levels to choose from.
The memory function stores the most recently set spray intensity.
Care and cleaning
Permissible cleaning agents and cleaning equipment
The use of foaming cleaning agents is permitted.
Cleaning agents must be dermatologically tested.
The use of abrasive cleaning agents, such as sand or scouring liquid, is not permitted.
The use of cleaning agents with a high chlorine concentration is not permitted.
The use of cleaning agents which may irritate the eyes or the skin is not permitted.
The use of corrosive cleaning agents, such as concentrated drain cleaners, is not
permitted.
The use of powdery cleaning agents, such as scouring powder or scouring agent, is
not permitted.
Cleaning agents must be uid.
Cleaning agents should ideally be diluted with water.
Cleaning agents are permitted to have a low acid content; e.g. they may
contain citric acid.
Non-permissible cleaning agents and cleaning equipment
Please refer to chapter "Care and cleaning" of these operating instructions for more
information about cleaning and care of the Geberit AquaClean 4000.