Genie IntelliG User instructions

Programming
Quick Reference Card
For detailed instructions refer to owner’s manual. 800-35-GENIE.
WARNING: DO NOT use wall console until limits have been set.
WARNING: Bullet MUST be engaged to carriage BEFORE setting limits.
Setting Limits & Remote Programming
for IntelliG®, TriloG™& GPower™Models
PROGRAM
SET
PROGRAM
SET – +
HOLD
2 seconds
HOLD
2 seconds
2Press and hold the down arrow button (-) for
2 seconds until the long LED comes on blue
(round LED remains off).
PROGRAM
SET – +
3Release down arrow button (-) and the long LED
will begin flashing.
PROGRAM
SET – +
PROGRAM
SET – +
HOLD
4Press and hold the down arrow button (-) until
garage door is fully closed on floor, then release.
PROGRAM
SET
PROGRAM
SET – +
5Press and release the Program Set button (both
LEDs flash blue and go off).
The down limit is now set.
Setting Down Limits: Setting Up Limits:
PROGRAM
SET
PROGRAM
SET – +
HOLD
2 seconds
HOLD
2 seconds
6Press and hold the up arrow button (+) for
2 seconds until the long LED light comes on blue
(round LED remains off).
PROGRAM
SET – +
7Release up arrow button (+) and the round LED
will begin flashing.
The up limit is now set.
PROGRAM
SET
PROGRAM
SET – +
9Press and release the Program Set button (both
LEDs flash blue and go off).
PROGRAM
SET – +
PROGRAM
SET – +
HOLD
8Press and hold the up arrow button (+) until door
is fully open, then release. Watch carriage as
it approaches the power head to avoid contact
with powerhead.
*If both LEDs turn RED at this time,
return to Step 1, Setting Down Limits.
P999-159 1M 1/13 JAR

19
Press and release the same button on the remote
(the door should open or close).
To clear remote memory completely from the power head -
Press the Program Set button on the power head and hold for
2 seconds. The round LED will come on. Release the Program
Set button and the round LED goes off. The long LED now
flashes purple. Press the up arrow button and down arrow
button simultaneously on the power head and hold until both
LEDs flash blue and go off.
Force and speed are set.
10 Open and close your garage door using the Wall
Console Open/Close button.
PROGRAM
SET – +
15
Release the ProgramSetbutton (the long LED
begins flashing purple).
PULL
16
Remove protective film for battery from remote.
PROGRAM
SET – +
17
Press and release the button you have chosen
on the Remote (long LED comes on purple).
PROGRAM
SET –
PROGRAM
SET –
18
Press and release the same button on the remote
(both LED’s flash blue and then turn off).
Setting Force & Speed:
PROGRAM
SET – +
HOLD
2seconds
14
Press and hold the Program Set button (the round
LED turns blue).
Programming Remotes: