Faire un appui long sur « POWER DOWN / ET DOWN ». Ou à l’aide de la commande (bouton rouge).
L’écran s’éteint.
Stockage des batteries:
• Ne pas exposer les batteries à l’eau et l’humidité
• tocker les batteries à température ambiante sans excéder 40 °C, et au dessous de -4°C
• tocker les batteries chargées à 30-50 % de la capacité.
• Ne pas laisser en plein soleil
• Ne pas exposer à de l’électricité statique
• Ne pas ouvrir, écraser, percer, incinérer
• Ne pas mettre en court-circuit
• N’utiliser que le chargeur fourni par le fournisseur
• Ne pas jeter la batterie après usage, la déposer conformément aux réglementations gouvernementales locales.
•Si la batterie entre en contact avec de l’eau ou tout autre liquide, la débrancher immédiatement
et l’isoler dans un endroit ouvert, loin de matériaux combustibles.
Introduction
Thank you for purchasing A60 Li- olymer Battery models
B12V-5200. lease read the entire user manual prior to use.
Li- olymer Battery is a slim and lightweight external
battery pack that will allow you to power a variety of heated products.
Features
• Ultra-lightweight construction reduces bulk and weight
• LED battery fuel gauge
• LED power level indicators
• B12V-5200 provides 5.200 mah of power
WARNING
• Do not attempt to disassemble or alter any part of this product.
• Do not store below – 4°C or above 40°C.
• Do not allow this product to have contact with water or other liquids.
If water or other liquids enter the battery interior, immediately
unplug the product from the battery. Continued use of the product
may result in fire or an electrical shock.
• Do not place this product near an external heat source or expose the
battery to direct flame or heat, as the battery may explode.
CAUTION
Failure to charge battery prior to use will reduce battery life.
CHARGE BATTERY REGULARLY:
It is important to maintain at least 25% of your battery power when
not in use. Failure to do this will result in performance problems and
reduced battery life.
Be certain to use your battery with products having an amp rating less
than the maximum capacity output rating for the battery. For
instance, the lithium battery pack has a maximum capacity output
rating of 4 amps and should not be used with heated products that
draw more than 4 amps. Please check your product’s amp draw before
connecting battery pack. Failure to do so can overheat the battery
causing damage.
Charging the A60 B12V-5200
To set up the charging process, proceed as follows:
1. Locate the input cable connector for the charger.
2. lug the AC power cord into a properly rated AC outlet (110v).
3. lug the chargers output cord into the battery output port.
4. The battery power level indicator LED is green when it’s fully charged or
red if charging is needed.
5. Charge battery until the red LED on the charger is a green color and all the
number 9 LED on the battery is illuminated. The battery is now fully
charged.
