
Notice for Operation
P.9
Operating Instructions
P.8
Preset Programs
Tousethepresetprograms,theusershouldrstselectthedesiredpresetprogrambyturningiDialtothepositionwhere
theprogramiconlightsup(theselectedprogramiconwillashonceselected).Then,pressthe“On/Off” button
to start. Press the “On/Off ” button again to stop the blender.
* The above recipes are for reference only. Actual ingredient portion is subject to personal preference.
Icon Program Descriptions LCD Display Suggested Recipes
Bisque
Accelerate to speed 7 in 5 sec. Then
accelerate to speed H in 5-10 sec and
keepatthisspeeduntilnish.Totaltime
is 8 min.
80g onion, 50g celery, 30g
Chinese onion & 500g yellow
sweet potato slightly stir-fried;
500ml boiled chicken stock,
300ml water, fresh cream,
salt, sugar, pepper
Sauce
Speed 8 for 2 sec and pause for 1 sec.
Repeat for 5 cycles. Then speed H for
45 sec. Total time is 1 min.
300g peeled tomato, 200g
tomato paste, 100g dried
tomato, 50g basil, 10g parsley,
40g onion, 40g sugar, 20g
salt, 10g minced garlic
Soy Milk
Accelerate from speed 1 to speed 5 in
5 sec, and run at speed 5 for 25 sec;
thenspeed8for30sec;nallyspeed
Huntilnish.Totaltimeis6min.
150g soy bean (soak in
hot water for half an hour),
500ml distilled water, 60g
sugar
Smoothie
Speed H for 8 sec and pause for 2 sec.
Runincyclesuntilnish.Totaltimeis
30 sec.
100g fresh pineapple fruit
(cut into pieces), 300ml
pineapple juice, 500g ice
cube
Nuts
Speed 5 for 5 sec. Then Speed 8
for 2 sec and pause for 1 sec (repeat
10 times). Total time is 35 sec.
205g wheat, 80g coffee bean
Vegetable
Speed H for 30 sec and pause for
2 sec; then speed 6 for 10 sec and
pause for 2 sec; then speed H for 60
secandpausefor2sec;nallyspeed
6 for 10 sec. Total time is 1 min 56 sec.
1/4 cucumber, 1 stalk celery,
1 apple, 600ml distilled
water
Time Display
Speed Display
Time Display
Speed Display
Time Display
Speed Display
Time Display
Speed Display
Time Display
Speed Display
Time Display
Speed Display
- Insert the measuring cup to the lid (align the arrow on the cup to the symbol on the lid and turn it to
position).Thenpressdownonthelidoftheblenderjartoclose.Toopen,pullupbytheapofthelid.
- During operation, close the lid tightly to avoid injuries due to spilling or splashing of hot liquids.
- Wind part of the power cord underneath the unit base. Prevent rubber foot from stepping on the power cord.
- When the food is too thick or there is too little liquid in the jar, the motor will be dragged to a low speed or cease
to operate. Hence, when blending thick and sticky food, start blending from low to high speed. If it is still unable
to blend, disconnect the power and stir the food inside the jar using a rubber stirrer to drive out the air trapped
in food. Then close the lid and switch on the blender to continue the operation.
- When overheating is sensed, the temperature monitoring system will be activated and would stop the operation
of the motor. In this case, put the appliance in a place with good ventilation to cool it down for 45 minutes. The
system will be reset and you may resume the operation of the appliance.
- Keep hands and utensils out of the container while the motor is running to prevent the possibility of severe
personal injury and/or damage.
- In making hot beverage or soup (such as soy milk, porridge, bisque, etc.), please ensure that the lid is secured
tightlytothejartopreventitfromfalling.Pleasebeadvisedtostarttheoperationatlowspeedrstandthen
gradually increase the speed, or simply use the “Pulse” mode.
-Whenmakingsauces(eg.almondsauce,jamandsesamesauce),stufngandnuts,putinbetween2and3
cups of ingredients. The amount should neither be too large or too little. Keep the blending time below 2 min to
prevent any burnt smell due to overheating. Too much ingredients may lead to overloading and overheating of
the motor. In this case, wait till the motor temperature falls before operating again.
- Please put liquid and soft food into the jar before putting in hard food or ice cubes.
- Whentheoperationnishes,pleasewaituntilthebladeassemblycomestoacompletestopbeforetakingup
the blender jar.
- If you notice a burnt smell from the blender, stop the operation immediately. It may be caused by the abrasion
at the rubber cushion base if it is not properly assembled.
- Do not operate continuously for over 10 minutes each time.