Oil Debris Sensor
earDetect
W
gillsc.com
© 2021 Gill Sensors & Controls Limited
Tools Required
• 2mm hex key
• 36mm Spanner
• Thread Sealant (NPT only)
• Optional Threadlock (Loctite 270 or similar)
Getting Started
• Unpack the adaptor and grub screws, checking the adaptor is the correct size for the application
before tting it to the sensor.
• For applications subject to high environmental vibration, apply thread lock to the grub screws.
• Fit the grub screws into the adaptor, without tightening.
• Fit the adaptor to the equipment using the sealing washer (or thread sealant for NPT adaptors) to a
torque of 50Nm.
• Fit the the sensor probe into the thread adaptor, pushing fully to ensure the at rear surfaces of the
two parts are level.
• Secure the two parts by tightening the grub screws to a torque of 1Nm.
Note: The grub screws supplied are designed for use with the Gill tting. Please do not substitute alternatives
as this may compromise the security of the tting.
The use of thread lock between the adaptor and sensor results in a permanent tting. Removal of sensor
head requires removal of the adaptor.
The adaptor is intended for use with the Gill Oil Debris sensor and should not be used with any other sensor.
Any one of the three apertures can be
used to secure the sensor
