GMP ELECTRO ULTRA LAMITRIM-1800 User manual

LEADERS IN LAMINATION TECHNOLOGY
User Guide 20000505
ELECTRO ULTRA
LAMITRIM-1800, 2500
User ’s Guide
Before operating the unit, please read this manual thoroughly and retain it for future reference.
Operating Instructions

IMPORTANT SAFETY INSTRUCTION
TABLE OF CONTENTS
WARNING
1. Each electrical part is protected with safety cover.
Do not remove the cover on your own.
2. Do not place your figures in area near the blade during operation.
IMPORTANT SAFETY INSTRUCTIONS
ADVANTAGES
NAME OF EACH PART
OPERATION OF CONTROL PANEL
TRIMMER OPERATION PROCEDURE
SPECIFICATIONS
1
1
3
4
5
5
ADVANTAGES
1) Trimming range can be set depending on the size of material to be trimmed.
2) Trim speed can be adjusted by analog speed control knob.
3) Use of rotary disc style blade reduces load on the unit and allows the unit to trim in
both directions.
- Speed is adjustable for operating on materials with different thicknesses.
- Cutting size, range, and position can be selected per trimming condition.
- Specially designed for laminated materials
- Paper Guides can be easily removed for trimming large size material.
- Blade can only travel between the distance of paper size selected on the control panel.
NAME OF EACH PART
A- REAR COVER
B- TOP PLATE
C- TRIMMER HOUSING
D- PHOTO SENSOR
E- CONTROL PANEL
F- SIDE COVER
G- PAPER GUIDE
ABC
D
E
F
G
H
I
H- PAPER GUIDE KNOB
I - STAND
J- ADJUST PAD
K- PAPER GUIDE PLATE
L - TABLE
M- RAIL
N- PC(Poly Carbonate) COVER
J
K
L
N
M
21
ENGLISH
ENGLISH

43
2. Operation Method and Technique
1. Sensor Location Display
Shows location of sensors installed.
Indicates range of blade movement upon operation.
2. Trimming Range Display
Displays distance and trimming range set by
sensor location in mm.
3. Adjustable Speed Control
Speed of the blade is indicated and controlled.
Turning it clock-wise will increase the speed,
counter clock-wise will decrease the speed.
4. Trimming Range Adjustment Key
Each key can select trimming location and range.
Trimming location and range can be selected
according to the size of material to be cut
OPERATION OF CONTROL PANEL
1. Name of Each Control Part
CONTROL PANEL
Sensor Location Display
Adjustable Speed Control
Trimming Range
Adjustment Key
Trimming Range Display
A4 : P3~P4(350mm)
A3 : P2~P3(500mm)
A2 : P2~P4(850mm)
A1 : P1~P2(950mm)
A0 : P1~P3(1450mm)
1800 : P1~P4(1800mm)
ENGLISH
ENGLISH