GOAL ZERO LIGHTHOUSE CORE User manual

1

1
Table of Contents
Get To Know Your Gear 2
How It Works 3
Technical Specifications 4-5
Français 6-9
Deutsch 10-13
Español 14-17
DEMO MODE
Take the Lighthouse CORE out of demo mode by
plugging the built-in USB cable into a live USB port.

2
CORE
Convenient Built-in hanger
USB Recharging Cable
Magnets for
Verstile Mounting
Battery Indicator Lights
1A USB Output
Light Dial
GET TO KNOW YOUR GEAR

3
1. Take the Lighthouse CORE out of demo
mode by plugging it into a live USB port with
the built-in recharging cable.
2. Turn the dial on top of the Lighthouse CORE
left or right for Dualite™ Directional Lighting
and brightness options.
3. Recharge the Lighthouse CORE by plugging
it into a live USB port with the built-in
recharging cable.
4. Charge phones and boost tablets by
plugging into the 1A USB output port.
HOW IT WORKS

4
Ports:
USB Port (output) 5V, up to 1A (5W max),
regulated
USB Port (input) 5V, up to 1A (5W max)
General:
Chainable No
Weight 0.8 lbs (351 g)
Dimensions 5 x 4.5 in
(12.7 x 11.4 cm)
Operating Usage Temp. 32-104 F (0-40 C)
Certs
Warranty 12 months
Be sure to register your product at goalzero.com/support
Charge times:
Nomad 7 5-10 hrs
USB Source 5 hrs
Run time:
One Side Lit (low power) 350+ hrs
One Side Lit (high power) 8 hrs
Both Sides Lit (low power) 200+ hrs
Both Sides Lit (high power) 4 hrs
Battery:
Cell Chemistry Li-ion NMC
Cell Capacity 16.3Wh (3.7V, 4400mAh)
Lifecycles Hundreds of cycles
Shelf-life Charge every 3-6 months
Fuses None
Management System Charging and low-battery
protection built-in
Light:
LED (output) Warm white LED 430 Lumens
Color Temperature 3,500 Kelvin
TECHNICAL SPECIFICATIONS

5
Ports:
USB Port (output) 5V, up to 1A (5W max),
regulated
USB Port (input) 5V, up to 1A (5W max)
General:
Chainable No
Weight 0.8 lbs (351 g)
Dimensions 5 x 4.5 in
(12.7 x 11.4 cm)
Operating Usage Temp. 32-104 F (0-40 C)
Certs
Warranty 12 months
Be sure to register your product at goalzero.com/support
TECHNICAL SPECIFICATIONS

SM061317
GOAL ZERO HEADQUARTERS
675 West 14600 South
Bluffdale, UT 84065
1-888-794-6250
Designed in the U.S.A.
Made in China
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordancewith
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that towhich
the receiver is connected.
—Consult the dealer or an experienced radio/TVtechnician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.