9
Output Value Settings
In the M mode:
•Press the group button to choose the group, turn the select dial, and the power
output value will change from Min to 1/1 in 0.3 stop increments. Press the <SET>
button to confirm the setting.
•Press <ALL> button to choose all group’s power output value, turn the select dial,
and all groups power output value will change from Min to 1/1 in 0.3 stop
increments. Press <ALL> button again to confirm the setting.
Note: Min. refers to the minimum value that can be set in M or Multi mode. The
minimum value can be set to 1/128 0.3, 1/256 0.3, 1/128/ 0.1, 1/256 0.1, 3.0(0.1) and
2.0(0.1) according to C.Fn-Min. For most of camera flashes, the minimum output value is
1/128 and cannot be set to 1/256. However, the value can change to 1/256 when using in
combination with Godox strong power flashes e.g. AD600, etc.
Flash Exposure Compensation Settings
In the TTL mode:
Press the group button to choose the group, turn the select dial, and the FEC value will
change from -3~3 in 0.3 stop increments. Press the <SET> button to confirm the setting.
Multi Flash Settings (Output Value, Times and Frequency)
•In the multi flash (TTL and M icon are not displayed).
•The three lines are separately displayed as power output value, Hz (flash
frequency) and Times (flash times).
•Press the <SET> button and turn the Select Dial to change the power output value
from Min. to 1/4 in integer stops.
•Press the <SET> button again and choose Hz to change flash frequency. Turn the
select dial to change the setting value.
•Press the <SET> button again and choose Times to change flash times. Turn the
select dial to change the setting value.
•Until all the amounts are set. Or during any value setting, short press the <SET>
button to exit setting status.
•In the multi flash setting submenu, short press the <MODE> button to return to
main menu when no values are blinking.