Goldair GCT110 User manual

Operating Instructions
CeramicTowerHeater
Model: GCT110

General Care and Safety Guide
Thank you for choosing a Goldair Ceramic Heater. This Goldair Heater has
been designed and manufactured to high standards of engineering and
with proper use and care, as described in this leaflet, will give you years
of useful service. Please read these instructions carefully.
1. Use only the voltage specified on the rating label
of the appliance.
2. Keep all objects at least 1 metre from the front,
sides and rear of the appliance. Do not place
appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this may
cause an electric shock, fire or damage to the
appliance. Do not sit on the appliance.
5. Do not operate this appliance with a damaged
cord, plug or after the appliance malfunctions or
has been dropped or damaged in any manner.
Return to a qualified electrical person for
examination, electrical service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended by
the manufacturer and may cause fire, electrical
shock or injury.
8. The common cause of overheating is deposits of
dust or fluff in the appliance. Ensure these
deposits are removed regularly by unplugging
the appliance and vacuum cleaning the air vents
and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always remove
plug from the mains supply before cleaning.
10. Do not connect the appliance to mains supply
until completely assembled and adjusted.
11. Switch off and use handles provided when
moving.
12. Do not operate with cord set coiled up as a heat
build up is likely, which could be sufficient to
become a hazard.
13. The use of an extension cord, power board, or
external timer is not recommended with this unit.
14. Do not remove plug from power socket until the
appliance has been switched off.
15. Do not remove plug from power socket by
pulling cord; always grip plug.
16. Always unplug appliance when not in use.
17. Do not locate the heater directly below any
power socket during operation.
18. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage area
and is unrolled before use.
19. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they are
supervised or have been given instruction
concerning the use of the appliance by a
person responsible for their safety..
20. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not
be immersed in any liquids.
21. When the appliance has been unpacked,
check it for transport damage and ensure all
parts have been delivered. If parts are missing
or the appliance has been damaged, contact
the Goldair Customer Services Team
22. If your appliance does not work, or is not
working properly, contact the place of
purchase or the Goldair Customer Services
Team. Repair work on the appliance by
unqualified persons can cause serious risk to
the user.
23. There are no user serviceable parts installed in
the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire
hazards.
25. This unit is not supposed to be used in or
around locations where foodstuffs, works of art
or delicate articles of science, etc are stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
28. Ensure heater is on a flat, stable, heat-
resistant surface.
TECHNICAL SPECIFICATION
Model No: GCT110
Power Supply: 220-240V, 50Hz AC only
Power: 1500W

Operating your Ceramic Heater
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday –Friday 8am-5pm
Phone: [phone]
Website: www.Goldair.co.nz
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device, automatically disconnects &
reconnects the appliance at a preset temperature.
The third device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! NEVER COVER THIS HEATER!
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents. In order to get the maximum heat,
the reflector must be kept clean.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically, since a
fire risk exists if the heater is covered or positioned
incorrectly.
WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
HEAT CONTROL SWITCH
The control switch positions are:
0 OFF
Fan without heater
I Low Heat
II High Heat
Check that the heat control switch is set to off
position before plugging the heater into the mains
supply. For greater economy, use the high heat
setting initially and then switch to the low heat
setting.
For the Low and High heat settings the fan remains
at the same settings, only the heating block
changes to create the greater/lesser heat output.
THERMOSTAT
Turn the thermostat knob clockwise until the
maximum temperature is obtained on the graduated
scale. When the desired temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
OSCILLATE
This button turns the heater oscillation function on
and off.
PLEASE NOTE: THE FAN WILL CONTINUE TO
RUN EVEN THOUGH THE ELEMENTS HAVE
SWITCHED OFF, THIS IS NORMAL
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.

Your Goldair product has been inspected and
tested and is guaranteed subject to the
following for a period of two years from the
date of purchase against defects in
workmanship and materials. During this
period, such defects will be rectified by repair
or replacement of the product purchased.
Your product contains no user serviceable
components and this warranty becomes
invalid if in our opinion the product has been
misused, abused, incorrectly installed,
tampered with, connected to an electrical
supply not corresponding with the name plate
specification, or subjected to power surges.
The warranty does not include any labour or
other associated expense that may be
involved in removal or installation of the
product. Normal wear and tear is expressly
excluded.
If your Goldair product fails to operate
satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a
repair or replacement product under this
warranty, you will need to produce satisfactory
evidence of date of purchase. The completed
warranty and purchase receipt must be
presented with the product. The warranty
should be filled out at the time of purchase. It
is in your interest to make sure this is done.
If the product is to be replaced (cannot be
repaired) then that replacement will be of the
same or similar product or accessory
excluding packaging, instruction card etc.
Where a replacement product is supplied, this
shall be guaranteed for the balance of the
original warranty period.
Any model that is no longer available will be
replaced by a model of a value and with such
features as we consider appropriate in the
circumstances. Goldair is not responsible for
freight forwarding charges, losses or damage
in transit.
If service is required after the warranty period
has expired, the product should be returned to
a qualified electrical technician. Service
outside of the warranty period will be at your
cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers
are advised that: The manufacturer does not
undertake that repair facilities and parts are
necessarily available for this product.
If any of the provisions of the foregoing are
contrary to any relevant legislation, then that
provision shall be deemed to be excluded from
the warranty and the rest of the provisions will
continue to apply.
Name ………………………………………………
Address ……………………………………………
……………………………………………………….
Suburb ……………………………………………
Purchased from …………………………………
Date of purchase …………………………………
Name of product …………………………………
Model no ……………………………………………
IMPORTANT: Please retain this warranty card
Two Year Warranty