CLEANING AND CARE
BEFORE FIRST USE
1) Before first use,fill the kettle with clean water to maximum capacity and boil．
Discard the water and repeat the process．
2) The kettle should always be unplugged when filling or adding water．
3) Fill the kettle with water to desired level.Do not overfill or there will be a risk of
spillage or spitting.The water level indicator will assist you to measure the correct
amount．You can fill the kettle via the spout or after opening the lid．Do not
forget to close the lid after filling，otherwise the kettle will not automatically
switch o after use.
4) Do not fill kettle with less than 0.5 liters of water（to “min” indication）to
prevent the kettle running dry while operating．
5) Do not fill with more than 1.7 liters of water（to “max” indication）．
6) An automatic safety cut-out has been fitted for protection against overheating.
it will operate when the kettle is switched on and it contains insucient water．
7) Always ensure the water inside the kettle covers the minimum mark on the
water level indicator gauge．If the automatic safety cut-out has operated，switch
the kettle o，disconnect from the power outlet and allow the kettle to cool down
for 5 to 10 minutes．Then refill and switch on,and the kettle will work as usual．
8) Place the power base on a dry, flat surface. Place the kettle on the power base.
The electrical connection will be made automatically as the kettle slides onto the
power base.
9) Plug the cord set on the power base. The electrical connection will be made
automatically as the kettle slides onto the base.
10) Plug the cord set into a grounded power socket and switch on by pushing the
switch of the kettle to the “on” position.
11) When the water has boiled, the kettle will switch o automatically. After
allowing the kettle to cool down for 15-20 seconds, the water can be brought
back to boil by pushing the switch back to the “on” position. During the cooling
down time do not force the on/o switch into the “on” position as this can
damage the operating mechanism.
12) Do not remove the kettle from the power base without switching o first.
13) Remember, if you do not wish to re-boil the kettle, switch it o.
14) The kettle may be switched o manually at any time by setting the on/o
switch into the “o” position.
8 9
HOW TO CARE FOR YOUR KETTLE
• Wipe the exterior of the kettle with a soft, damp cloth or sponge. Remove
stubborn spots with a cloth moistened with mild liquid detergent.
• Do not use abrasive scouring pads or powers.
• Never immerse the kettle in water or other liquids.
• From time to time, depending on the nature of your water supply, a boiled scale
deposit will naturally form and will be found mostly adhered to the heating
element, thus reducing the heating eciency.
• The amount of boiled scale deposited (and subsequently the need to clean or
rescale) largely depends on the water hardness in your area and the frequency
with which the kettle is used.
• Boiled scale is not harmful to your health. But if poured into your beverage, it
can give a powdery taste to your drink. Therefore, the kettle should be descaled
periodically as indicated below.
DESCALING
Descale kettle regularly. With normal use, descale at least twice a year.
• Fill the kettle up to “max” with a mixture of one part ordinary vinegar and two
parts water. Switch on and wait for the appliance to switch o automatically.
• Let the mixture remain inside the kettle overnight.
• Discard the mixture the next morning.
• Fill the kettle with clean water up to “max” mark and boil again.
• Discard the boiled water to remove any remaining scale and vinegar.
• Rinse the inside of the kettle with clean water.
STORAGE
Ensure product is dry before storing. Place in a cool, dry area to avoid humidity if
not used for long periods of time.
DISPOSAL
This product may not be disposed of along with with ordinary household waste,
as electrical and electronic waste must be disposed of separately.
Contact your retailer, distributor or the municipal authorities for further information
on product disposal.
WARRANTY DETAILS
This product is guaranteed under a one year limited warranty period, applicable to
the original purchaser and not transferable to a third party user.
Repair or replacement of defective parts are at the seller's discretion. In the event
that repair isn't possible, the seller will replace the product/ part. If product repair/
replacement won’t suce, the seller has the option of refunding the cash value of
the product or component returned.
Product defects not covered under the warranty provisions include normal wear
and damage incurred from use or accidental negligence, misuse of instruction
specifications, or repair by unauthorized parties. The manufacturing company is not
liable for any incidental or consequential damages incurred by such circumstances.
STORAGE AND DISPOSAL
