GPM STLDINPAL User manual

GLOBAL PROCUREMENT AND MARKETING LIMITED
1
Bar table & stools
Assembly Instructions – Please keep for future reference STLDINPAL DINTABPAL
Dimensions 1 MAN Assembly Time OW #
Width: 120cm 30 mins
(approx.)
DINTABNIC/
DINTABNIC
Depth: 60cm
Height: 95cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, please email aft[email protected]

2
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Check you have all the
components and tools listed
on pages 4 and 5.
Remove all fittings from the
plastic bags and separate
them into their groups.
Keep children and animals
away from the work area,
small parts could choke if
swallowed.
Make sure you have enough
space to lay out the parts
before starting.
Do not stand or put weight on
the product, this could cause
damage.
Assemble the item as close to
its final position (in the same
room) as possible.
Assemble on a soft, level
surface to avoid damaging the
unit or your floor.
We do not recommend the
use of power drill/drivers for
inserting screws, as this could
damage the unit. Only use
hand screwdrivers.
Dispose of all packaging
carefully and responsibly.
Care and Maintenance
Only clean using a damp cloth and
mild detergent, do not use bleach or
abrasive cleaners.
From time to time check that there
are no loose screws on this unit.
This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
If you are unhappy with the product and wish to return it,
please follow the retailer’s returns procedure.

3
Exploded View
If you have damaged or missing components,
email: [e-mail]

4
Components - Panels
Please check that you have all the components listed below before constructing your item.
Part No Description Qty Size
(mm)
Thickness
(mm)
1Table top 1
2Table side frame 2
3Table side bar 2
4Table under bar 1
5Chair seat 4
6Chair side frame 8
7Chair side bar 8
8Chair under bar 4
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, please email aft[email protected]
If you have damaged or missing components,
email: [e-mail]

5
Components - Fixings
Please check that you have all the components listed below before constructing your item.
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
(E) (F) (G) (H)
(E) (F) (G) (H)
Tools Required
Ruler – Use this to measure your screws (mm)
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, please email aft[email protected]
If you have damaged or missing components,
email: [e-mail]