Graco Simple Sway User manual

OWNER'S MANUAL
Simple Sway™

Failure to follow these warnings and the
assembly instructions could result in serious
injury or death.
•PLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
•THIS PRODUCT REQUIRES
ADULT ASSEMBLY. Follow
assembly instructions
carefully. If you experience
any difficulties, please contact
the Customer Service
Department.
•TO PREVENT SERIOUS
INJURY OR DEATH FROM
INFANTS FALLING OR
BEING STRANGLED IN
STRAPS:
•Always secure infant in the
restraint system provided.
After fastening buckles,
adjust belts to get a snug fit
around your infant.
• Never leave infant
unattended in swing.
• Never carry swing with
infant in it.
• Discontinue use of swing
when infant attempts to
climb out or reaches 30
pounds (13.6 kg).
STRANGULATION HAZARD:
•DO NOT suspend strings
over the product or attach
strings to toys.
•DO NOT place product in
any location where there are
cords, such as window blind
cords, drapes, phone cords,
etc.
•Strings can cause
strangulation. DO NOT
place items with a string
around your child’s neck,
such as hood strings or
pacifier cords.
• DO NOT USE THIS
PRODUCT if it is damaged or
broken.
•DO NOT place product near
water and moisture. Do not
use the product near possible
wet areas, such as a bathtub,
shower, wash basin, sink,
laundry tub, swimming pool,
wet basement, etc.
•DO NOT use the AC adapter
if it has been exposed to
liquids, has been dropped,
or is damaged.
• Protect the power cord. Place
it so it is not walked on or
pinched by furniture or other
items.
•DO NOT use with an
extension cord.
• Use only power cord
provided.

Parts list
This model may not include some features shown below. Check
that you have all the parts for this model BEFORE assembling your
product. If any parts are missing, call Customer Service.
FEATURES ON CERTAIN MODELS
Styles vary 3X
ALL MODELS
Seat Assembly
Leg Assembly Accessories

Seat Assembly
1Make sure seat frame straps are
not twisted or wrapped around
the metal tubs.
SNAP!
Attach seat frame at the bottom
of seat.
SNAP!
2
3
Attach seat frame at the top of
seat.

4
Insert seat wire into the wire hole
and channel on both sides.
5
Insert the top of seat frame into
seat pad.
Wrap the pad around the bottom
seat frame.
6

8Working from the outside in,
snap the seat pad around the seat
wire as shown.
7
Attach the seat pad to the seat
wire as shown.
SNAP!
SNAP!
SNAP!

2
Insert motor housing
tubes to leg tubes as
shown.
Assembling Swing Frame
1Place carton on ground.
Lay unit down as
shown. Plug wires
together as shown and
insert wires inside tube.
SNAP!

Insert side base tubes into
leg tubes as shown.
SNAP!
4
Insert front base tubes
into side base tubes as
shown.
3
SNAP!

Installation complete.

Installing Seat
Insert rectangle end of the
hanger tube into motor housing.
Repeat for other hanger tube.
CHECK that hanger tube is
secured in housing by pulling
firmly on it.
SNAP!
1