Graco MyRide User manual

To Remove Existing Harness Tongues and Buckle and Attach Replacement Buckle
11
12
45
3
Remove chest clip.
DO NOT DISCARD the
chest clip.
78
10
9
6
Remove harness
strap loops from
splitter plate.
Pull harness straps
through seat back and
seat pad.
Unbuckle harness by
tilting top of buckle
down, press top of red
button, and pull
tongues out of buckle. Remove and discard
tongues.
Slide NEW buckle onto
harness straps. MAKE
sure not to twist straps.
Re-attach chest clip.
MAKE sure not to
twist straps.
Re-insert straps through slots
in seat pad and seat back.
See carseat owner’s manual for inserting
the straps into the correct set of harness
slots for your child.
Insert harness straps
behind harness cover
plate.
To loosen straps, lift lever
and pull harness straps.
MyRide ® Buckle Replacement Guide
Turn page over to
¿QLVKWKHUHVWRI
the assembly
Steps 12 to 20
for the buckle
replacement.
©2013 Graco PD245610A 5/13
Re-insert straps back onto splitter plate.
See carseat owner’s manual for inserting the
splitter plate into the correct set of loops for
your child.

19
17
13 14
16
15
12
20
19
18
Unfasten the 4 clips at the
front of the seat pad. Pull
pad up then pull buckle
through crotch slot.
Reach under seat to the
metal retainer.
Push the retainer up
through bottom of seat and
remove buckle and discard.
Push button and
remove tongues from
the NEW buckle.
Insert metal retainer
from NEW buckle into
crotch slot in the seat
bottom as shown.
Re-insert buckle
through the slot in
seat pad.
Pull up on buckle
to be sure it is
secured in the slot.
Wrap seat pad around
edge of seat.
Re-attach 4 button
clips to front of seat.
Insert NEW tongues
into buckle.
Any questions please
contact us at :
Graco Children’s Products
3 Glenlake Parkway
Atlanta, GA 30328
1-800-345-4109
www.gracobaby.com
CLICK!
FINAL CHECK :
7XJRQWKHEXFNOHWREHVXUH
it is properly secured in the
bottom of the seat and does
not come out.
0$.(685(WKHKDUQHVV
straps are not twisted.
0DNHVXUHWKHFKHVWFOLSLV
properly threaded as shown
in Step 8.