Green Brook DW081A-C User manual

1. Open the over of the Magneti
sensor with a flat s rewdriver. A
gentle twisting will remove the
over of the sensor.
2. Insert two size “AAA” alkaline
batteries in the sensor, observ-
ing the polarity.
3. Set the house odes (1-16)
inside the sensor, it must be
mat hing with the ode set in
the re eiver.
4. Set 3position slide swit h to
sele ted tune (see diagram 2)
Note: different sensors an all
be set to different tunes if
required.
5. There is a test swit h at the
ba k for testing with re eiver
before mounting.
6. Lo ate the sensor and the
magneti pie e (see dia 1) on
the opening su h as door or
window. Do not mount the
sensor on a metal surfa e.
7. Mount the ba k plate on a
desired area with the 2s rews
supplied. Sele t a mounting
lo ation no further than 50m
from the re eiver, a tual
working range depends on the
number of walls that the signal
has to pass through.
8. Pla e the ba k plate in the right
position, drill two 4.76mm
holes and insert the wall plugs,
then tighten the plate on to the
wall with the s rews (dia. 2.6x
26mm) supplied.
9. Position the sensor over the
ba k plate so that the lip on the
ba k plate engages into the slot.
INSTALLATION
• Wireless Magneti Sensor
(Door/Window Alert)
• For use with wireless Door himes
•433MHz, 16 ode settings
• Up to 50M range
•2x “AAA” Batteries
• Indoor use only
• CE - EMC / LVD / R&TTE approved
• RoHS omplian e
DW081A-C
Securi y Window Sensor

PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
sales@greenbrook. o.uk
WWW.GREENBROOK.CO.UK
Issue No: 701463
IMPORTANT
No naked flame sour es, su h as
lighted andles, should be pla ed near
the unit.
The unit should not be exposed to
dripping or splashing. Repla e the
batteries only with the same or
equivalent type re ommended by the
manufa turer. Please dispose of old,
defe tive batteries in an environmen-
tally friendly manner in a ordan e
with the relevant legislations.
Indi ating separate olle tion
for ele tri al and ele troni
equipment
Push the sensor ba k to the ba k
plate until it snaps over the ba k
plate.
10.The sensor will be triggered
when door/windows open and
the re eiver will alert and sound.
Diagram 2
LED will light up
when the sensor
is being triggered
Diagram 1