Green Brook DW080A-C User manual

1.Open the over of the PIR sensor
with a flat s rewdriver. A gentle
twisting will remove the over of
the PIR Sensor.
2.Insert two 1.5V “AA” alkaline
batteries in the PIR sensor,
observe polarity.
3.Set the house odes (1-16), it
must be mat hing with the ode
set in the hime re eiver.
(Diagram A)
4.Use the 3position slide swit h to
sele t a different hime tune.
Note - PIR sensor and bell push-
es an be set to different tunes.
(Diagram A)
5. Use 2-position slide swit h to
adjust the HI/LOW sensitivity.
Fa tory pre-set to low sensitivity.
This adjusts the range of the PIR
Sensor. (Diagram A)
6.Lo ate a good position indoor or
outdoor within the dete tion
range of the PIR Sensor.
7.Pla e the ba k plate in the hosen
position, drill two 4.76mm holes
and insert the wall plugs, then
tighten the plate on wall with the
s rews supplied. Do not mount
on or next to a metal surfa e.
8.Position the over over the ba k
plate so that the lip on the ba k
plate engages into the slot. Make
sure the rubber gasket is properly
seated. Push the PIR over ba k
to the ba k plate until it snaps into
position.
9.The PIR Sensor dete ts any
INSTALLATION
•For use with wireless himes
• Use instead of, or in onjun tion with
other bell pushes to alert the approa h
of visitors/intruders
•433MHz, 16 ode, up to 50M range
• Dete tion range 3M
• Dete tion angle 60 degree
•2x1.5V AA battery
• Indoor & Outdoor Use
• CE-EMC / LVD / R&TTE approved
• RoHS omplian e
DW080A-C
Sec rity PIR Sensor

movement within the dete tion range
(3M) and angle (60 degree) and will
sound the re eiver.
PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
sales@greenbrook. o.uk
WWW.GREENBROOK.CO.UK
Issue No: 701462
IMPORTANT
Diagram A
The unit should not be exposed to
dripping or splashing.
Repla e batteries only with the same
or equivalent type.
Please dispose of old, defe tive
batteries in an environmentally friendly
manner in a ordan e with the
relevant legislations.
Indi ating separate olle tion
for ele tri al and ele troni
equipment