Growers SOLUTION Quonset Low Sidewall User manual

These Photo’s are for
Reference only.
All Greenhouses are assembled in a similar
fashion. Use these Photo’s as a guide along
with your instruction manual. If you are unsure
about assembly, Call Us @ 866-928-3390

Quonset Greenhouse

Low Sidewall Greenhouse

High Sidewall Greenhouse

Figure 1.1 - Taking Measurements on outer edge

Figure 1.2 - Use string around all 4 corners

Figure 2.1 - Lay bows flat and slide together

Figure 2.2 - Secure joints with 2 Tek-Screws

Figure 4.3 - Connect purlin using 2-hole strap, on the first and last bow

Figure 4.4 - Use purlin clamps on remaining bows

Figure 5.1 - Attach base board with 2-hole straps down sides. Attach base
board with L brackets on endwalls.

Figure 5.2 – Attach hip/head board with 2-hole straps down sides. Place a Tek-
screw through 2-hole strap to secure to ground stake.

Figure 7.1 - Attach wire base on hip/head board if you have rollup sides.
Attach wire base to base board if you do not have rollup sides.

Figure 7.2 - Place a wire base between hip board and base board

Figure 7.3 - Attach wire base to face of hip/head board

Figure 8.1 - Lay film over wire lock channel and fasten with wire lock

End Wall Instruction Pictures

Figure 2.1 – For 36” Door Opening.
Find Center of greenhouse then measure 18.5” to the left and right

16 ft Low Sidewall End Walls

20 ft Low Sidewall End Walls