Guardian LINGO Setup guide

Your pendant has already been programmed by us.
It is working and ready to go!
Follow these steps so you will be ready in an emergency.
PROFFESSIONAL MONITORING
QUICK START USER GUIDE
Guardian
SAFETY PENDANTS
READ THIS FIRST!
Step 1.
Turn your pendant on. Press the side button until it vibrates
(4-5 seconds), then release. A voice prompt will announce that it
is turning on. (See illustration 1)
Step 2.
Connect the lanyard to the Lingo. Unless you plan to carry it in
some other way. (See illustration 2)
Step 3.
Press the SOS button until it vibrates (2-3 seconds), then release.
A voice prompt will announce, “Your alarm has been activated.
Cancel by pressing the SOS button.” (See illustration 3)
Step 4.
Cancel the SOS by briefly pressing the SOS button. A voice
prompt will announce, “Your alarm has been cancelled.”
Alternatively, do not cancel, and the Monitoring Company
will soon be called. (See illustration 3)
Step 5.
Recharge your Lingo by connecting the USB cable to the wall
plug and the other end to the Lingo (See illustrations 4, 5 and 6).
When connected, a voice prompt will announce, “Your alarm is
charging.”
1.
2.
3.
4.
5.
6.
Turn over this Page for answers to FAQ
Illustrations

F A Q
QUESTION RESPONSE
Is the Device ready to go?
What do the emergency contacts
need to do in an emergency?
How do I cancel the Fall Alert after
it starts beeping?
Why didn’t Fall Detection sound
after a fall?
What do the lights mean?
How do I reprogram the device if
people’s phone numbers change?
Why didn’t the GPS work?
Why is the Device not charging?
Yes! Just turn it on and you’re good to go.
Press the SOS button once briefly to cancel the Fall
Alert when you hear the voice prompt.
Due to the varied nature of falls, some falls may not
register. We can adjust the sensitivity if necessary.
However, in the event of a fall, do not wait for the Fall
Alert voice prompt but press the SOS button if you are
conscious.
Just call us! We can do this for you.
GPS works best when there is a clear view of the
sky. When initially receiving your Lingo, turn it on
and take it outside for a couple minutes. Send the
text message: “0000,A00” to confirm your GPS is
working.
See Useful Codes (page 8) in the Full User Guide for
more information.
Confirm the Lingo is connected as shown on the other
side of this sheet. If any of the 4 connection points on
the back of the Lingo become dirty or discoloured,
clean them with alcohol wipes or multipurpose
cleaner and a toothbrush.
The GREEN light shows:•Phone Reception
The BLUE light shows: •GPS Reception
The RED light shows: •Battery Charge
See LED Indicators (page 5) in the Full User Guide for
more information.
© 2021. Guardian Safety Pendants Pty Ltd. All rights reserved
The Monitoring Company will call your contacts as
part of their emergency process. They will call your
emergency contacts to let them know the SOS button
has been pressed and ask how to proceed from there.