GW Instek GOM-804 Quick start guide

GOM-804/805
(Firmware Upgrade Quick Guide)
Andy Kung
[email protected]om.tw

2
Hardware / Software requirement
Hardware
Machine
Cable
PC
Software
Programmer
Driver
Firmware
USB driver
•

3
Install LM Flash programmer and DFU / USB driver to PC
Software Installation
Save firmware(Master & Slave) into a file folder
For required software, please visit GW website
on “Download” section
https://www.gwinstek.com/en-
global/products/detail/GOM-804_GOM-805

Connection
4
Use USB cable(A / B type), connect machine & PC

5
Notice
There are two stages for
firmware upgrade ~
Slave &Master
Incorrect operation might cause
unable to power the display on,
Please execute carefully

Slave Firmware Upgrade

Slave Firmware Upgrade (1)
7
Power ON
Press and hold the “ESC” & “Range” key, then press “POWER” key
Release the “ESC” & “Range” key until screen shows….Slave Update

8
Slave Firmware Upgrade (2)
Select “USB DFU” from
Interface section
Confirm “Device Firmware
Upgrade” appearing in
message box. If not, plug
USB cable again and then
press “Refresh “button
Open LM Flash Programmer
Click on /Texas Instruments/LM Flash Programmer and then complete
the Configuration setting

9
Slave Firmware Upgrade (3)
Confirm
“Program
Address Offset “
is 0 x 2800
Select file & start programming
Into Program page, press ”Browse” to select Slave file
Make sure the Program Address Offset: 0x 2800
Press ”Program”
to start
programming

10
Slave Firmware Upgrade (4)
Programming Program Complete