H.264 4 CH Multiplex DVR User manual

USER MANUAL
1

USER MANUAL
2
Contents
1. Function overview and Characteristics............................................................................................................................ 4
2. Introduction of DVR .............................................................................................................................................5
2.1 Introduction of the front panel.................................................................................................................................... 5
2.2 the rear panel（Just for your reference,please accord to the real products）.......................................................... 6
4CH DVR rear panel（Just for your reference,please accord to the real products）.......................................... 6-7
8-16CH DVR rear panel(Just for your reference,please accord to the real products）....................................... 7-8
2.3 DVR Remote controller(Just for your reference,please accord to the real products) .................................................. 8
3. Connect DVR ......................................................................................................................................................9
3.1 Installing the Hard Disk Drive....................................................................................................................................... 9
3.2 Connecting the cameras and monitors........................................................................................................................ 9
3.3 Connecting the Power.................................................................................................................................................. 9
4. Boot DVR...........................................................................................................................................................10
4.1 Login........................................................................................................................................................................... 10
5. DVR Menu.........................................................................................................................................................10
5Shortcut menu ......................................................................................................................................................... 10-12
5.1Main Menu Leading Sheet......................................................................................................................................... 13
5.2Main Menu ................................................................................................................................................................ 14
5.2.1 General（Language/Video standard/Resolution/System time/Transparency/Tour）................................. 14-15
5.2.2 Record（Channel/Resolution/Frame Rate (FPS)/Bit Rate Type/Quality/Recording Schedule）.................. 15-16
5.3 Network ..................................................................................................................................................................... 17
PPPoE Setup--NTF Setup—EMAIL Setup -- IP FILTER--DDNS—FTP—ARSP .................................................................... 17-21
Alarm Server—Wireless config —Mobile Monitor —UPNP---Wi-Fi—RTSP………………………….......….…………………………21-24
5.4Alarm .................................................................................................................................................................. 24-25
5.4.1 Motion Detection .......................................................................................................................................... 25-27
5.4.2 Video Blind ......................................................................................................................................................... 27
5.4.3 Video Loss........................................................................................................................................................... 28
5.4.4 Alarm input......................................................................................................................................................... 28
5.4.5 Alarm output ...................................................................................................................................................... 29
5.4.6 Abnormality ........................................................................................................................................................ 29
5.5Switch ........................................................................................................................................................................ 30
Digital channels …………………………………………………………………………………………...................………………….......…………31-32
remote access configuration....................................................................................................................................... 33
5.7 System ...................................................................................................................................................................... 33
5.7.1 HDD Manage....................................................................................................................................................... 34
5.7.2 PTZ Config ........................................................................................................................................................... 35
5.7.3 GUI Display.......................................................................................................................................................... 35
5.7.4 Backup ................................................................................................................................................................ 36
5.7.5 Account.......................................................................................................................................................... 38-40
5.7.6 Device Info .......................................................................................................................................................... 40
5.7.7 Restore................................................................................................................................................................ 40
5.7.8 Auto Maintain..................................................................................................................................................... 40
5.7.9 Upgrade .............................................................................................................................................................. 41
5.7.10 Import/Export................................................................................................................................................... 41

USER MANUAL
3
6. NETWORK ACCESS SETTINGS AND CLOUD TECHNOLOGY INTRODUCTION ....................................................................42
6.1 LAN access settings........................................................................................................................................... 42-43
6.2 Cloud technology functions and using introduction ......................................................................................... 43-45
6.3 Client CMS software operation ......................................................................................................................... 45-47
6.4 Mobile Phone Monitoring....................................................................................................................................47-49
7. FAQ and use and maintenance ...........................................................................................................................49
7.1 FAQ.................................................................................................................................................................... 49-52
7.2 Use and maintenance ............................................................................................................................................ 52
Notes
Please pay attention to the following safety precautions to avoid personal injury and prevention damage for the
products and all other devices connected to it.
1. Please Use the appropriate power supply (note: use power supply which manufacturers pre-installed or specified)
Please don't use the power to supply this product,which haven't specified
2. Please don't put anything into the DVR
Please don't insert anything in the DVR box in order to avoid electric shock or other accidents
3. Please don't put in the dusty place
Avoid to put this product in a dusty place.
4. Please don't let this product expose in the rain or damp environment;
Avoid to put this product in the environment like a damp basement. If there is water inside inadvertently, please
unplug the power immediately and contact the local dealer
5. Keep the surface of the product clean and dry;
Only could use a small amount of water to clean the cover of DVR (no solvent)
6.If there is any suspicious fault, please stop the operation
If there is any abnormal sound or smell from DVR, unplug the power immediately and contact the authorized dealer
or service center.
7. Don't try to disassemble the top cover
Warning: don't disassemble the top cover DVR, in order to avoid electric shock.
8. Handle with care;
If the DVR run into hard objects accidentally, which leads to the DVR cann't work normally, please contact the
authorized dealer to repair or replacement.
9. Please use the standard lithium batteries (note: use battery which manufacturers pre-installed or specified)
After power off, if the system clock can't continue to work, please replace the standard 3V lithium battery on the
motherboard.
Warning: before replace the battery,please make sure DVR is turned off, otherwise it may cause serious electric
shock. Please appropriately handled the old battery.
10. Please put the product in a well-ventilated environment
There is hard disk drives in the DVR, the devices will produce a lot of heat in the process of operation, so don't
block the vent of cooling system when it's running(including the top, bottom, sides and back),please install or put the
products in a well-ventilated place.
11. The power adapter accompanied with the DVR just can supply power for one DVR, if it connects with more DVR one
time, will cause the DVR repeatedly restart because of lack of power.
12. This equipment should not be subjected to water or water splash, the device should not place objects filled with
liquids such as vase

USER MANUAL
4
1 Function overview and Characteristics
Function
Description
Real-time
Surveillance
Support monitor, VGA and HDMI output(some models support,please refer the
real products), support network client software, mobile phone real-time monitor
function,ZOOM, Tour, PIP
Video
Function
Video compression standard H.264,video quality,record resolution, video frame
rate adjustable. Support different record mode:Record when powered
on,Manual,Schedule,Motion Detection,Alarm,Remote etc.
Video
Storage
Support large capacity of hard disk with SATA interface, instant video storage
Playback
Support single channel or multi-channels classified inquiry and playback through
the DVR or network
Backup
Support Backup from DVR to USB, removable hard disk, DVD writer;and backup
from network to hard disk
Alarm Setup
Support alarm management of the hard disk and video input, support external
alarm signal input
Network
Operating
Support cloud access (www.dvrcenter.net),one step to the remote access, easy to
setup
Mouse
Operation
Support USB mouse operation, set up the system parameters conveniently
and quickly
PTZ Control
Support PTZ decoders through the RS485 communication, PTZ and dome camera
control functions,PTZ preset auto cruise
表1-1
Feature：
H.264 Vedio compression format
G.711A Audio compression format
Windows style graphical operation interface, embedded real-time Linux operating system
Human menu prompts
●All real-time Multi-operation(preview, record, playback, backup, network surveillance, mobile monitor)
Support Dual-stream network transmission
Support smart phone video surveillance
Support ZOOM,tour
●Adjustable video package time
A variety of alarm mode
USB2.0 interface, can support backup, DVD-writer, software upgrades, mouse operation
Supports infrared remote control
Support multi-language
Support system automatic maintenance
● DVR/HVR/NVR function 3-in-1 design, can receive multi-mode video signal input,Support analog signal, network HD
signal（some models support,please refer the actual machine).

USER MANUAL
5
2 Introduction of DVR
2.1 Introduction of the front panel
Front panel button operation function list(Note: This manual is an universal manual, Please refer the real products).
No.
Button name
Mark
Function
1
Function
switching
button
FN
Switch to the main menu/enter the corresponding page of auxiliary function menu
2
Direction
button
< >
Move the cursor
Add or reduce number during edit state
Change the settings in the menu
Enter the single channel or multi-channels when preview

USER MANUAL
6
< >
Move the cursor when the main menu or submenu pops up
Move the cursor during the playback mode
Enter previous or next channel surveillance during single channel surveillance
Main
menu/Confirm
button
ENTER
Confirm
Enter main menu or next submenu
3
Cancel button
ESC
Back to the previous menu or exit the menu operations
Back to the real-time surveillance during playback
4
Slow play
►
Play in the multi-low or regular speed during playback
5
Fast play

Play in the multi-fast or regular speed during playback
6
Playback/paus
e button
II/
Play the record in reverse or pause during playback
7
Play/pause
button
/II
Play the record or pause during playback
8
Recording
button
REC
Start/stop the video recording manually. With the direction button to choose the
recording channel
9
Recording
search button
SEARCH
Search recording files
10
PTZ control
button
PTZ
Enter PTZ setting, PTZ control
11
Main menu
button
MEAN
Enter the main menu settings
12
Images switch
button
DISPLAY
Switch single or multi channels
13
Network
connection
indicator light
LINK
Network connects normally if lighted,Otherwise the light isn’t bright
2.2 Introduction of the rear panel
4CH DVR panel 1
4CH DVR panel 2

USER MANUAL
7
4CH DVR panel 3
8CH DVR panel 1
8CH DVR panel 2
8CH DVR panel 3
16CH DVR panel 1

USER MANUAL
8
(1)Video input (2) Video output (3) Audio input/ output (4) USB interface
(5) Network interface (6) RS-485 interface (7) Power interface (8) VGA output
(9) Alarm input/output (10)HDMI interface
2.3 DVR Remote controller(Just for your reference, according to the real products)
Remote controller operation
Serial number
Name
Function
1
Multi-window
button
Same function as Multi-window button on the front
panel
2
Numeric button
Password input/number input/channel switch
3
【Esc】
Same function as【Esc】button on the front panel
4
Direction button
Same function as direction button on the front panel
5
ADD
Input the DVR ID to control it
6
FN
Assistant function
7
Record control
Control the record
8
Record mode
Same function as “Record mode”

USER MANUAL
9
3 Connect DVR
3.1 Installing the Hard Disk Drive
Note: please don't remove the hard disk when the DVR power is turned on
Hard disk installation:
(1) Loosen the screws on the left, right, and rear sides When is DVR power is turned off,and then remove the top cover.
(2) Connect the data and power cables of hard disk with the DVR motherboard. Attach the HDD to the bracket using 4
screws.
(3) Install the top cover.
Noted:If the user has high demand on HDD, we suggest to use the special hard disk for security and protection .
3.2 Connecting the cameras and monitors
Connect the camera signal to the DVR video input via BNC Cable, then Connect the DVR video output to the
monitor via VGA. If the camera support PTZ control, connect the camera cable to the DVR video input via RS-485
interface.
System connection diagram,For example 16CH DVR connection as follows:
.
Picture 2.1 System connection diagram
3.3 Connecting the Power
Please use the power adapter connected to the DVR that came with the DVR. After connection,please check to
make sure that the audio and video input/output interface are well connected.

USER MANUAL
10
4 Boot DVR（Taking 4CH DVR as an example as follows）
4.1 Login
When the DVR boots up, the user must login and the system will provide the corresponding function according to
the user authority. There are 3 user settings: Admin, Guest and Default. If the user name default Admin,there is no
password.Admin is as super user. Guest and default are the common users under factory settings.
Password protection: If you enter the wrong password three times, the alarm will start. If you enter the wrong
password five times, the account will be locked.
5 DVR MENU
5 Shortcut menu
5-1
In preview mode you can right click mouse to get the shortcut menu, as picture 5-1。The menu includes:
Main Menu: Access main menu to adjust all settings.
Playback：Playback the record files in the hard disk.
Record Mode：check current channel status
PTZ control：The functions include: PTZ direction control, step, zoom, focus, iris, and setup preset point, cruise
points, patrol track, boundary scan, assistant switch, light switch, horizontal rotation and so on.
Note: 1. Before operation,please make sure the Decoder 485+、485- line well connected with DVR 485+、485- line.
2. Before operation,click “main menu”“system”“PTZ Config” to set the PTZ parameters.
3. The PTZ functions are decided by the PTZ protocols.