H-KING FOKKER-D7 User manual


WORLD WAR 1 GERMAN FIGHTER PLANE
INSTRUCTION MANUAl
Made in China

1
1. Please read this manual carefully and follow the instructions before you use this product.
2. This airplane is not a toy, due to it's advanced flying qualities it is only suitable for experienced
pilots. If you are a novice then please only operate with the assistance of an experienced pilot.
3. Not recommended for children under 14 years old.
4. Please set up this plane according to the instructions and make sure you keep your hands and
other parts of your body out of the way of the rotating propellers at all times. Failure to do so will
result in damage to yourself and to the airplane.
5. Do not fly in thunderstorms, strong winds or wet weather.
6. Never fly R/C planes where there are overhead power lines, automobiles, airports, railway lines
or near a highway.
7. Never fly R/C planes where there are crowds of people or over organised games. This airplane
requires a very flat landing and take-off area that is clear of tree's and other obstacles.
Remember safety is the responsibility of the pilot.
8. Do not attempt to catch the plane when you are flying it.
9. The operator will bear the full responsibility of flying and the proper operation and usage of
this model. We at Hobbyking will not be responsible for any liability or loss due to improper use
of this model.
SAFETY INSTRUCTIONS

2
Undercarriage assembly.
S
Specications: Features:
Wing span: 925mm
Fuselage length: 720mm
All up weight: (820-840 grams)
Servos: 9 grams x 4 pcs
Motor: A2212 KV1000
ESC: Hobbyking 20 A with BEC
Propeller: 11 x 5
Battery: 3S 2200mah 40C (recommended)
Lightweight balsa and plywood construction
High quality covering lm
Authentic undercarriage with scale WW1 wheels
Large battery hatch for easy access
High quality hardware included
High quality motor, ESC and servos included
Easy to assemble

3
Undercarriage assembly.
Self-tapping screws with washer x 2pcs, self-tapping screws x 16pcs, machine screws x 4pcs and
nylon wing bolts x 2pcs.

4
the landing strut with two holes each side onto fairing and slide the axle through as shown.
Use a 1.7mm self-tapping screw each side to secure the strut to the fairing.

5
Spring the 2nd wheel strut over the axle as shown.

6
to do not overtighten to
Thread the supplied plain nuts onto the axle to secure the landing struts. Apply some
Loctite glue to the threads to prevent them from loosening. Install the wheels on either side
of the axle.

7
Rudder fin assembly.
Installing the elevator onto the horizontal stabilizer.
.

8
Aer the glue has set apply some CA glue between the fuselage and the stabilizeras shown. Set it
letaside to the glue dry.
Install the fin onto the stab as shown, remove any covering where the glue is going to be applied.
Trial t the n into the slots in the fuselage, ensure it will sit perpendicular to the stabilizer.
Remove the n and apply CA glue to the tabs and all the mating surfaces. Slot the n back into place
and check frequently that it remains perpendicular while the glue dries.

9
your ngers to the assembly.
hinges into the slots in the rear of the n and the rudder post. Ensure the hinge gap is minimal
but sucient to allow the rudder to move freely.