Hallis Hudson Professional Dual Rise User manual

Professional Dual Rise
I’ve produced this step by step guide to assembling a
Professional Dual Rise Roman Blind from components,
to create a child safe by design system with your
choice of customised touches such as chain,
cord pull and wand options.
Tools you will need
• Pencil
• Tape Measure
• Hacksaw
• T10 Torx Bit or Allen Key
• Cutting Pliers if using a metal chain
• Small Pick Tool
Mark off on the headrail and cut it down
ensuring it is 1.8cm shorter than the overall
width of your blind.
Cut down the axle rod and ensure it is
10.8cm shorter than the overall with of
your blind.
Take each spool and ensuring each grey
button is up, insert them into the headrail.
Make sure that the cord guides on the first and last
spool are facing outwards, this ensures your cord is as
close to the end of the blind as possible.
Attach the axle rod into the Dual Rise gear
housing and tighten firmly using a T10
torx key.
Insert the axle rod through each of the spools
inside the headrail.
Slightly undo the small screws on the top of the
Dual Rise gear housing taking care to ensure
it doesn’t come out and push it inside the headrail.
NOTE: once in about three quarters of the way turn the
headrail over and lift up the small flap so it goes over
the top of the headrail.
Push the final section of the Dual Rise gear
housing firmly in, ensuring it sits flush with
the headrail.
01
05
06
07
02
03
04
by Marc Brown, Product Manager.
01
02
03
05
06 07
04

If necessary, adjust the position of the cord
pulls by removing the cord connector and
cutting off more chain so they sit in your chosen position.
Using a T10 torx key tighten up both screws
on the top side of the headrail as well as the
single screw on the bridge.
Cut two chains to the desired length, we
recommend the front chain is 4cm shorter than
the back to help differentiate between the two.
Take a small pick tool and pull the clear ball
chain connector from the inside of the white
cord cover and attach your chains ensuring you fit the
longer chain at the back depending on if you have
fitted this on either the right or left hand side. This process
is the same if you choose to fit a wand or chain. If fitting
a wand skip to step 13, after step 10.
09
12
13
14
10
11
08
Take your chosen cord pull and pass your
chain through the small opening in the end.
Then fit an 0908R chain connector to the bottom of the
chain, Repeat the process for the second chain.
Position the spools where required and attach
the cord to each spool ensuring that you fully
press down on the grey button.
Pass the cord through the cord guide.
You can now attach your blind to the headrail and
continue to cord up the blind in your usual way.
08
12
13
14
09
10
11