HAMPTON BAY L08207 User manual

Item #1006 684 101
Model #L08207
Use and Care Guide
HB 6PK LV BLACK PATH LIGHT
Part Description Quantity
ALamp cover 6
BLens 6
C
D
Body 6
E
Post 6
F
Spike 6
G
Connector 6
H
12W transformer 1
I
Cable 1
Control box 1
PACKAGE CONTENTS
Assembly and Installation
1Attaching and installing the pathlight
WARNING:
to insert the spike (D) into the ground.
CAUTION: Safe for outdoor operation.
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
WARNING
or bulb protector.
Install the plastic lenses (B) in the lante
Carefully remove the fixture from its protective packaging.
rn body (C), attach the
post (D) to the body (C) and insert the spike (E) into the post (D).
Attach lamp cover (A) to the plastic lense (B) and turn them
clock wise.
WARNING: Install in accordance with all local codes and ordinances.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTIO
N.
PATHLIGHT ETL LISTED UNDER MODEL # L08207.
Please read and save these instructions.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS.
Lighted lamp is HOT!
2Connecting the wires
WARNING: The wire connector (F) contacts have sharp edges for pie rcing the
main low-voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low-voltage power unit shall be 12-18 AWG type
underground low energy circuit cable or SPT2W.
IMPORTANT:
•
building structu
Protect the wiring by routing it in close proximity to the light fitting or next to a
re such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6 in. (15.24 cm).
•
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
WARNING: There are no serviceable parts inside the power supply unit. DO NOT
DISASSEMBLE.
WARNING: Do not submerge the transformer.
WARNING: Do not connect two or more transformers in parallel.
WARNING: For use with 12-volt-low-voltage outdoor landscape lighting system only.
Not for use with submersible light or pool/spa equipment.
WARNING: Do not use with a dimmer.
CAUTION: Plug the power supply unit directly into a GFCI outlet that is marked “wet
location”. The maximum output of this transformer is 24 watts. Do not overload
the
to the transformer is equal to or less than 24 watts. This garden light system must be
transformer. Be sure that the total cumulative wattage of all 12-volt fixtures connected
installed in accordance with all local codes and ordinances. If you are experiencing
WARNING: Do not use an extension cord.
A
F
B
C
D
E
G
H I
A
B
C
D
E
F
- 1 -

Assembly and Installation (Continued)
CAUTION: BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
This control box (I) is weatherproof and suitable for outdoor use.
Do not install behind shrubs. It will affect the dusk-to-dawn
photocell.
Photocell will not operate properly if installed too close to a
nighttime light source.
The control box (I) goes between the transformer (G) and the
cables. Plug them together and secure them with screw caps.
3Installing the control box
4Connecting the cable to the transformer
Connect the wire to the transformer (G).
Screw the watertight connector by turning clockwise.
Plug the transformer (G) into the GFCI receptacle.
I
G
Note: Prior to installing and powering the transformer, a safety approved GFCI receptacle
(fig. 1) and GFCI watertight protective cover (fig. 2) (not supplied) must be installed by
a qualified electrician.GFCI receptacle and cover must be mounted a minimum of 12 in.
(0.3 m) above ground level. The transformer must be mounted at least 1 ft. (0.3 m) above
ground level.
- 2 -
Press the top half of the connector into the bottom half until it clicks
into place and is secure. This will pierce the low voltage wire and
connect the light to the transformer.
Align the low-voltage wire and fit it into the connector (F) bottom
half as shown below.
Test the connection by plugging in the transformer to see if the light
turns on. If it does, unplug the transformer and continue the install-
ation. If it does not, unplug the transformer and check the connec-
tion between the transformer and low-voltage wire, reinstall the
connector, and ensure power is available to the outlet you are using.
Once the connection is secure, repeat the process for the remaining
lights.
Once all lights are connected, it is recommended to wrap each con-
nector with electrical tape for additional protection.
After all fixtures are installed, turn on the transformer by plugging it
into an outlet.
Note: If you want to install this with your existing low-voltage lighting
system, skip step 4 and instead plug the lights into your existing
18AWG to 12AWG SPT-2W wiring.

Care and Cleaning
Troubleshooting
Warranty
Cable Selection
Do not use any cleaners with chemicals, solvents or harsh abrasives.
light.
Only some lights
work.
• There is no power.
• There is a disconnection or break in
the wire.
• There is a light source near the
transformer.
•connected to the transformer.
connector or LED.
• Check that the power is on.
• Check if there is a loose connection at the transformer screw terminal.
• Make sure the photocell is not near a lighting source.
•
• Check the connector to make sure the wire stabs have pierced the landscape
wire.
Problem Possible cause Solution
WHAT IS COVERED
purchase. This warranty applies only to the original consumer and only to products used in normal use and service. If this product is found to be
defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion,
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
portion of the product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specifically purpose, other than
the warranty contained her
damage, including but not limited to any labor / expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.HAMPTONBAY.com
Total Fixture Wattage
0-60 Watts
61-120 Watts
121-180 Watts
181-240 Watts
241-300 Watts
600W Transformer = (2X300) Watts
900W Transformer = (3X300) Watts
51-100 feet
Cable Length
101-150 feet
18 AWG 16 AWG 14 AWG
16 AWG 14 AWG 12 AWG
14 AWG 12 AWG NOT RECOMMENDED
14 AWG 12 AWG NOT RECOMMENDED
12 AWG NOT RECOMMENDED NOT RECOMMENDED
12 AWG NOT RECOMMENDED NOT RECOMMENDED
12 AWG NOT RECOMMENDED NOT RECOMMENDED
0-50 feet
12 VOLT TAP
Total Fixture Wattage
0-60 Watts
61-120 Watts
121-180 Watts
181-240 Watts
241-300 Watts
600W Transformer = (2X300) Watts
900W Transformer = (3X300) Watts
51-100 feet
Cable Length
101-150 feet
16 AWG* 16 AWG 16 AWG
16 AWG* 16 AWG 12 AWG
14 AWG* 14 AWG 12 AWG
14 AWG* 14 AWG 12 AWG
12 AWG* 12 AWG NOT RECOMMENDED
12 AWG* 12 AWG NOT RECOMMENDED
12 AWG* 12 AWG NOT RECOMMENDED
0-50 feet
15 VOLT TAP
Additional landscape lighting cable can be purchased at your local Home Depot store.
* NOT RECOMMENDED FOR HALOGEN LANDSCAPE LIGHTS
- 3 -
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from the date of