Happy Beds Headboards User manual

Headboards
Assembly Instructions
www.happybeds.co.uk
Important before assembly:
Health & Safety:
Check the contents of the product before
attempting to assemble this product.
It would be sensible to lay a rug or a carpet on the
floor where you intend to assemble the product, to
avoid scratches and damaging the product.
Please keep small parts out of reach of children.
DO NOT use this product unless all fixings are secured.
3 mins
Assembly
These tools are not
necessary, but may help
to assemble the product.
Do NOT use any power
tools as this may cause
damage.
Screws
4x
Wooden Struts
2x
Headboard
1x
Parts & Fittings Check List
1. There are four stapled areas at the back of
the headbaord. In between each stapled
area, you will feel a hole for the screws, to be
used to fasten the struts.
Instructions
1.

3. If fitting onto a divan bed base, locate the
headboard holes at the end of the base.
4. With the bolt screws (provided with the
bed-base and not the headboard), press
the bolt screws into the base holes until
meeting resistance.
Proceed to screw the bolt screws clockwise,
leaving enough space for the headboard
struts to fit into place.
2. Align the struts and the
holes correctly on the
bottom-half of the
headboard.
With the four screws
supplied, fasten the struts in
position.
The headbaord is now ready
to fasten to the bed base.
5. Once the headboard is at the desired
height, tighten the bolt screws until the
headboard is locked in place.
(Please note: 5ft King Size and 6ft King Size
bases usually come with 4 bolt screws,
whereas the other smaller sizes will come
with only 2 bolt screws)
If you have problems assembling or have damaged or missing
pieces, please contact us by visiting:
https://www.happybeds.co.uk/customer-service
Fitting onto a base
2.