Hasbro 3116 User manual

AGES 4+
3116
Buzz Lightyear’s Intergalactic
Headquarters & Buzz Lightyear’s
Star Command Cruiser
Playset comes with skiff, radar dish,
launchers, 2 projectiles, prisoner
containment unit, spaceship, space
rover vehicle, Buzz Lightyear figure and
Zurg figure.
Thank you for purchasing this Toy Story toy! For maximum play value, be
sure to read and follow instructions.
Batteries included. Replace with 3 x
1.5V “AA” or R6 size batteries. Alkaline
batteries recommended. Phillips/cross head
screwdriver (not included) needed to replace
batteries.

To Assemble
To Play
• Snap center section of playset
onto base.
• Snap-on gun/scope and radar
dish can attach to several
places on the playset.
• Snap prison cell onto center
section as shown.
• Snap prisoner containment
unit onto prison cell.
• Push slide up and down to
move elevator!
• Prison cell swivels out!
Note: To conserve batteries,
move switch to “OFF”
position when youʼre not
using the playset.
• Make sure ON/OFF switch is
in “ON” position for electronic
lights and speech.
ON/OFF
switch
• Push button on gun to fire
projectile!

To Play (continued)
To replace computer–screen light bulb
Use a Phillips/cross head screwdriver to loosen
screw in computer screen base (screw remains
attached to base). Remove screen. Remove light
bulb and spacer. Replace exhausted bulb with
a fresh PR7 or 1.1 watt bulb. Replace door and
tighten screw.
• Dock skiff in front of computer
screen, then press gently on skiff
for electronic speech and lights!
(Electronic features can also be
activated by pressing button
under the computer screen.)
• Squeeze containment unit shut,
then detach and snap onto skiff!
Button
• 2 docking stations for skiff (indicated by red dots)!
Spacer
• Zurg figure fits inside
containment unit when placed
inside as shown. If figure is
placed in any other position,
unit will not close properly.
• Buzz Lightyear figure has hole
in back to fit backpacks (sold
separately).

© Disney/Pixar
®* and/or ™* & © 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
03116 P/N 6390320000
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-327-8264
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including any interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow
the toy and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert them
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from other
electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if
necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from
the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
To Replace Batteries
Use a Phillips screwdriver (not included) to loosen
screw in battery compartment door (screw remains
attached to door). Remove door and remove old
batteries. Insert 3 x 1.5V fresh “AA” or R6 size
batteries. Alkaline batteries recommended.
Replace door and tighten screw.