Hasbro Baby Alive Baby Wanna Walk User manual

5008(98859000_BA_BabyWannaWalk.indd)2012-01-093/T/FW120-6/2012-01-06
PMS PMS
3145 1925
FCC STATEMENT
This device complies with Part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) This device may not
cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
NOTE: This equipment has been
tested and found to comply with
the limits for a Class B digital
device, pursuant to Part 15 of
the FCC Rules. These limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy, and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment does
cause harmful interference to
radio or television reception, which
can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between
the equipment and receiver.
• Consult the dealer or an
experienced radio/TV technician
for help.
CAUTION: Changes or
modifications to this unit not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully.
Use only batteries specified and be sure
to insert them correctly by matching
the + and – polarity markings.
b. Do not mix old batteries and new
batteries or standard (carbon-zinc) with
alkaline batteries.
c. Remove exhausted or dead batteries
from the product.
d. Remove batteries if product is not to be
played with for a long time.
e. Do not short-circuit the supply
terminals.
f. RECHARGEABLE BATTERIES: Do not mix
these with any other types of batteries.
Always remove from the product before
recharging. Recharge batteries under
adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected
by, local electrical interference, move it
away from other electrical equipment.
Reset (switching off and back on again
or removing and re-inserting batteries) if
necessary.
IMPORTANT: BATTERY INFORMATION
AGES 3+
Baby Wanna Walk™
Baby Wanna Walk™
Quick Start
1.Move switch
to ON.
2.Press
tummy
button.
3.Touch
hands—let
go quickly
or hold on!
Detailed instructions
inside.
Questions? Call 1-800-327-8264
Product and colors may vary.
© 2011 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
98859 & A0202 PN 7258810000
x4 1.5 V A A
ALKALINE
BATTERIES
REQUIRED
DEMO BAT TERIES
INCLUDED

5008(98859000_BA_BabyWannaWalk.indd)2012-01-093/T/FW120-6/2012-01-06
PMS PMS
3145 1925
Move your doll’s TRY ME/OFF/ON switch to the
ON position. Then press her tummy to activate
play mode.
Make sure your BABY WANNA WALK doll is
standing up. Move your doll’s legs into standing
position if needed.
Walking
Tummy button
NOTES:
• If you stop playing with your BABY WANNA WALK doll, she
will go into sleep mode. Press her tummy to return to play mode.
• To conserve batteries, turn switch to OFF when doll is not to be played with
for extended periods of time.
• Play with your doll on smooth surfaces or low-pile carpeting.
• Hold her hands—she walks with your help!
• Let go of her hands—watch her walk by herself!
• Touch her hands and let go quickly to see if she
will start walking on her own!
TO REPLACE BATTERIES
TROUBLESHOOTING
IMPORTANT CLEANING
INSTRUCTIONS
• Clean doll’s face and body by wiping
gently with a soft, damp cloth.
Do not rub.
• Do not submerge doll in water; it is not
intended for bath-time play.
1. Locate battery compartments in
doll’s shoes.
2. Loosen screws in battery
compartment covers (screws
remain attached to covers).
2. Remove covers.
3. Remove and discard demo
batteries.
4. Replace with 4 x 1.5V AA
alkaline batteries.
5. Replace covers and tighten
screws.
If your BABY WANNA WALK doll is unresponsive, or if sounds become
erratic, the battery power may be low. Replace batteries.
Replace demo batteries with alkaline batteries. Phillips/cross head screwdriver
(not included) needed to insert batteries.
Press her tummy
for giggles!
TO PLAY
TRY ME/OFF/ON