Hasbro My Little Pony So Soft Crawling Pinkie Pie... User manual

®
Thank you for
purchasing this
My Little Pony®
product!
Please read these
instructions
carefully to
ensure proper
care and use.
AGES 3+
So Soft Crawling Pinkie Pie™
64788/64047 Asst.
x3
BATTERIES INCLUDED
Replace with 3 x 1.5V “AA” or LR6 size alkaline batteries.
Phillips/cross head screwdriver (not included) needed to
replace batteries.
So Soft Crawling Scootaloo™
64789/64047 Asst.

GETTING STARTED
PLAYING WITH THE TOY
TROUBLESHOOTING
CLEANING TIPS
This product is packaged in “DEMO” mode.
Activate its full range of features by moving the
PLAY/OFF/ DEMO switch to the “PLAY” position.
Switch is located on pony’s stomach (undo fabric
fastener to access switch).
NOTE: This toy uses battery power whenever its switch is in the
“PLAY” position. To help conserve battery life, move the switch to
“OFF” position when you’re not playing with the toy.
DEMO
PLAY
Press your pony’s back and
she’ll say a phrase and start
to crawl while wiggling her
tail. Press her back again
and she’ll say more random
phrases and continue
to crawl. After about 30
seconds of non-activation,
she’ll say a phrase and go
to sleep. Re-activate by
pressing pony’s back again.
Her head can be manually
positioned.
If your pony does not respond or is acting erratically, (1) move the
PLAY/OFF/DEMO switch to “OFF”, then back to “PLAY” and/or (2)
replace the batteries.
• Clean the pony’s face and body by
wiping gently with a soft, damp cloth.
• Do not submerge the pony in water; it
is not intended for bath-time play.
press
back

CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
TO REPLACE BATTERIES
PLAY
Undo fabric fastener to access
battery cover. Using a Phillips/cross
head screwdriver (not included),
loosen screw in battery compartment
cover (screw stays attached to
cover). Insert 3 x 1.5V “AA” or LR6
size alkaline batteries (not included).
Replace cover and tighten screw.
Re-attach fabric fastener.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and
be sure to insert item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reinsert batteries if
necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.

9e8U``XQ<[ZeO[Y
BU_U`
© 2007 Hasbro. All Rights Reserved.
TM & ® denote U.S Trademarks.
64788/64047 Asst. and 64789/64047 Asst.
PN 6780420000
Product and colors may vary.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Questions? Call 1-800-327-8264