Hasbro Buzz Lightyear's Electronic Power Blaster... User manual

AGES 4+
03074
Thank you for purchasing this Toy Story toy! For maximum play
value, be sure to read and follow instructions.
Buzz Lightyear’s
Electronic Power Blaster
Batteries included.
Replace with 3 x 1.5V
“AAA” or R03 size
batteries. Alkaline
batteries recommended.
Phillips/cross head
screwdriver (not
included) needed to
replace batteries.

Playtime
• Press red button to flip out
wings and hear the phrase
“To infinity. . .and beyond!”
• To reset wings, twist
clockwise and lock into
place.
• To wear blaster on wrist,
fasten wrist strap to belt
clip, then wrap around wrist
as shown.
• Press yellow button for electronic speech, sounds and lights! Each time
you press the button, lights will flash and Buzz Lightyear will say one of
the following sequential
phrases: “To infinity…
and beyond!”, “I have
Zurg in my sights!”,
“Firing laser!”
• Press button a fourth
time to hear a laser-
firing sound effect.
Press button again to
begin sequence anew.
lights
Yellow
Button
Red
Button

To Replace Batteries
Use a Phillips screwdriver to loosen
screw in battery compartment
door (screw remains attached to
door). Remove door and remove
old batteries. Insert 3 x 1.5V fresh
“AAA” or R03 size batteries.
Alkaline batteries recommended.
Replace door and tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries, or standard (carbon-
zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.

HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-327-8264
© Disney/Pixar
®* and/or ™* & © 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
03074 P/N 6352850000
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including any interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.