Lower the handle to access the battery compartment door. Use a Phillips/cross head
screwdriver (not included) to loosen screw in battery compartment cover (screw
remains attached to cover). Remove cover. Insert 3 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Replace door, and tighten screw.
NOTE TO UK CONSUMERS: This product and its batteries must be
disposed of separately at your local waste recycling centre. Do not
dispose of in your household waste bin.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and –
polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-
zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other
types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Make sure landing gear is up. Insert 6 missiles into each gun. Lower handle. Press trigger to launch one missile from each gun.
Slide front of jet backward and forward for LOCK & LOAD action; this action “engages” the next 2 missiles. Pull trigger to launch
the 2 engaged missiles. Keep repeating the LOCK & LOAD/ring sequence to launch all 12 missiles.
NOTE: If you pull the trigger without locking/loading rst, you will activate sounds
and lights, but the missiles will not re.
Pull latch up to lower cockpit.
Figure ts in cockpit. Manually
push cockpit up to close it.
Landing gear can be lowered and raised manually.
NOTE: Make sure you raise the landing gear be-
fore you re the missiles.
Handle can be lowered
and raised manually.
Flashing lights and
weapon sounds are
activated each time
missiles are red.
Weapon sounds and vehicle lights
Pilot communication sounds
Engine sounds and lights
2
3
1
ON/OFF SWITCH: Slide switch to turn vehicle on or off.
(located under vehicle)
*
*
