Hasbro Star Wars Vintage Series User manual

CREATIVE DEVELOPMENT STUDIOS // CREATIVE COMMUNICATIONS
NAME Kate Adams FLAT SIZE / SPREAD 20 x 6 in FOLDS N/A
NOTES BOOKLET :
2 SPREADS / 8 PAGES
EMAIL [e-mail] TRIM SIZE (PDP) 10 x 6 in COLORS 2C : BLK / 485C
READ BEFORE UNPACKING.
ASSEMBLY REQUIRED. NO TOOLS NEEDED.
AGES 14+
JABBA’S SAIL BARGE
(THE KHETANNA)TM
VEHICLE
E25962040_359543_SW_E6_HASLAB_JABBAS_SAIL_BARGE_KHETANNA_INST.indd 1 9/13/18 5:09 PM

11
2
3
4
4
55
2 3
STOP! Do you have a Barge Buddy? We recommend assembling Jabba’s Sail Barge with
a friend. It’s precious cargo, and the perfect assembly is all about nding a balance.
UNPACKING
NOTE: DO NOT HOLD BARGE BY RAILINGS.
The main portion of the ship is packed out as
one piece. Additional pieces are stored in the
accessory box beneath.
To protect the barge, prepare a soft surface like a
bed, a blanket on the oor, or a tauntaun carpet.
Remove Jabba the HuttTM gure and Yak FaceTM
gure/card from foam end pieces and set aside (1).
Remove center foam brace (2).
Slide accessory box out from below barge and
set aside (3).
Tear plastic bag down middle along perforation
and slide plastic away from center (4).
Carefully hold barge from underneath while gently
removing plastic and end foam pieces, one at a
time (5).
With the help of your Barge Buddy, carefully place
the barge onto the soft surface you’ve prepared.
Gently roll the barge away from you onto its side
to begin assembly.
Find ns and side antennae in the
accessory box.
Snap keyed portside and starboard
antennae into place as shown (1).
Slide portside and starboard ns behind side
mounts and snap pins into place, making sure
that pin marks are facing inwards toward ship (2).
NOTE: Fins are intended to pivot slightly.
SUPPORT FEET, FRONT ANTENNA
AND ENGINE DETAILS
FINS AND SIDE ANTENNAE
ASSEMBLY
Find support feet, antenna, and engine details in the
the accessory box.
Attach support feet. Support feet MUST be attached
prior to attaching ns.
For additional support, keep one hand on the deck
of the Barge while attaching feet. Snap each keyed
foot into place. NOTE: Feet are removable for
storage purposes.
Press bottom antenna into place as shown (1).
Press engine details into place as shown (2).
2
1
2
1
E25962040_359543_SW_E6_HASLAB_JABBAS_SAIL_BARGE_KHETANNA_INST.indd 2-3 9/13/18 5:09 PM

4 5
4
3
ASSEMBLYASSEMBLY
Locate the 3 cannons (2 rail, 1 main deck),
in the accessory box.
For main deck cannon: attach cannon on
main deck with a one-time snap. Cannon
is intended to swivel and elevate (1).
For rail cannons: attach cannons on any
of 6 ports on the deck railing. Cannons
are intended to swivel and elevate (2).
CANNONS Assemble the Khetanna’s legendary
sails.
Gather all pieces necessary for sail
assembly from the accessory box.
Roll out sail.
Attach small braces to main
horizontal beams as shown (1).
Secure and snap main horizontal
beam and V-shaped structure piece
as shown (2).
Insert ends of horizontal beam into
sail pockets (3).
Slide sail tabs into the V-shaped
structure piece (4).
Insert round end of anchor into
V-shaped structure piece round
hole (5).
Insert square end of anchor into
V-shaped structure piece square
hole (6).
COLLECTOR’S NOTE:
For those collectors who
own the Star Wars The
Black Series Vizam gure
and cannon, there are 4
C-clip ports to connect
Vizam’s cannon. (Figure/
cannon not included and
not available for sale.)
5
2
33
1
SAILS
12
6
E25962040_359543_SW_E6_HASLAB_JABBAS_SAIL_BARGE_KHETANNA_INST.indd 4-5 9/13/18 5:09 PM

PLAY
6 7
ASSEMBLY
SAILS
Once sails are assembled, insert
upright supports into deck mounts (1).
Insert anchors (x4) into holes on side
of ship (2).
NOTE: Sails can be attached and
detatched at your leisure. It is
recommended that you remove sails
for open deck play.
EXTERIOR PLAY
POP-OFF PANELS (1-5)
Carefully lift panels
from the bottom to
remove. Remove front panel
to reveal cockpit. Remove 3
side panels and back panel
to reveal interior. NOTE:
When snapping panels
back into place, it is best to
start with the panels at the
back of the ship and move
forward towards the front.
TRAP DOOR (6)
Press button below
rail to release trap
door. Reset manually
from below deck.
DECK HATCHES
Deck hatches slide
or lift open.
”BREAK” IN RAILING (7)
”R2, where are we going?!”
Railing piece is removable
to recreate R2-D2’s leap
from the deck of the
Khetanna.
REAR SHUTTERS (8)
Rear shutters can be pushed
open from behind for
added ventilation. Do not
pry open shutters that do
not readily open as they are
NOT intended to be open.
COCKPIT
Cockpit holds 2 gures.
JAIL SHACKLES (9)
Included chains and shackles can
attach to foot of gure. (Additional
gures not included).
SLIDING JAIL DOOR (10)
Slide door back and forth to trap or
release prisoners.
SMUGGLER’S HATCH (11)
Remove oor piece to reveal
smuggler’s hatch.
ARMORY (12)
Store weapons in armory as shown.
JABBA’S DAIS
Slide Jabba’s dais back and forth to scan
for shady denizens.
INTERIOR PLAY
2
3
1
4 5
7
6
8
11
9
10
12
2
1
E25962040_359543_SW_E6_HASLAB_JABBAS_SAIL_BARGE_KHETANNA_INST.indd 6-7 9/13/18 5:09 PM

STARWARSHASBROCOM STARWARSCOM
TM*
Some poses may require additional support.
© & ™ Lucaslm Ltd. ®* and/or TM* & ©2018Hasbro, Pawtucket,
RI02861-1059USA. All Rights Reserved. TM&®denote U.S.
Trademarks. US/CANADATEL.1-800-255-5516. E2596 PN00033642
E25962040_359543_SW_E6_HASLAB_JABBAS_SAIL_BARGE_KHETANNA_INST.indd 8 9/13/18 5:09 PM