Havis-Shields Telescoping Computer Base C-TCB-34 Configuration guide

C-TCB-34_INST_9-07
INSTALL INSTRUCTIONS C-TCB-34
TELESCOPING COMPUTER BASE
2004-2008 GMC / CHEVROLET CANYON/COLORADO
TOOLS REQUIRED:
Ratcheting Wrench
Standard & Metric Socket Set
Power Drill
Drill Bit Set
HARDWARE:
QTY DESCRIPTION PART #
2 ¼” x 1” Hex head lag bolts GSM33060
1 5/16-18 Nylock Nut GSM30017
1 5/16-18 x 1” Hex head bolt GSM33012
2 5/16” Flat Washers GSM31006
1 Pole Support Assembly CM97031-34W
1 Lateral Cross Brace 110-000034
1 Inner Telescoping Pole Assembly CM93072-1
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles computer a false
reading, causing a warning light on the instrument cluster. This requires the vehicles’ computer to be reset with
a vehicle diagnostics tool.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use only hardware provided with install kit.
 For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email [e-mail] or call 1-800-524-9900 and
ask for technical support.
SUB ASSEMBLY:
1. Confirm receipt of all parts.
2. Remove passenger side, front seat bolts.
INSTALLATION:
1. Mount C-TCB-34:
• Press back on seat and slide Pole support
assembly between seat bracket and floor of
vehicle.
• Line up slots in Pole support assembly with
bolt holes on floor.
• Reattach bolts removed in sub-assembly.
Hand-tighten only.
• Attach Lateral cross brace to tab on side of
TCB using 5/16-18 x 1” bolts, washers and
Nylock nut. Tighten.
• Pre-drill 5/32” holes into floor of vehicle where support brace and floor meet.
• Attach to vehicle using (2) ¼” x 1” Hex head lag bolts.
• Completely tighten seat bolts and insert Telescoping Pole.
Inner Telescoping
Pole Assembly
Lateral Support
Brace
Pole Support
Assembly