Havis-Shields Universal Telescoping Computer Base C-TCB-14 Configuration guide

C-TCB-14_INST_8-07
INSTALL INSTRUCTIONS C-TCB-14
UNIVERSAL TELESCOPING COMPUTER BASE
TOOLS REQUIRED:
3/16” Allen wrench
Ratcheting Wrench
Standard Socket Set
Powered Drill (if necessary)
Drill Bit Set (if necessary)
HARDWARE:
QTY DESCRIPTION PART #
1 Pole support assembly CM93071-14W
1 Telescoping pole assembly CM93072-14
4 ¼-20 Nylock nut GSM30016
4 ¼” Flat washer GSM31005
4 ¼ - 20 x ½” Hex head bolt GSM33000
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. C-TCB-14 offers multiple mounting options.
a. Havis Shields extruded Trak Mount
b. Any flat surface with access to bolt.
3. Mounting option to be determined by installer.
Pole support
assembly
¼-20 x ½” Hex head
b
olts, washers & hex
nuts
Location to mount to
Trak or flat surface
Telescoping pole
assembly

C-TCB-14_INST_8-07
INSTALLATION:
1. Mount C-TCB-14 to Havis-Shields Trak Mount:
• Mount console, transmission hump bracket(s), and Trak mount being sure to leave
room for C-TCB-14
• Slide (4) ¼-20 x ½” Hex head bolts, (2) in each rail.
• Place Pole support assembly so slots line up with hex head bolts on Trak mount.
• Secure with ¼” Flat washers and nylock nuts.
• Attach optional C-3090 Computer mounting platform to Telescoping pole assembly.
Note: It is recommended to leave all components loose on Trak until exact positioning is determined.
2. Mount C-TCB-14 to flat surface:
• Exact location to be determined by installer.
• Position C-TCB-14 on floor or other flat surface in vehicle.
• Mark and drill ¼” holes.
• Bolt using ¼-20 x ½” Hex head bolts, washers and nylock nuts.
• Attach optional C-3090 Computer mounting platform to Telescoping pole assembly.