Havis-Shields Dual In-Dash Microphone Clip Bracket 1996-2007 Ford Crown Victoria... Configuration guide

C-MCB-CV-INST-6-07
INSTALL INSTRUCTIONS C-MCB-CV
DUAL IN-DASH MICROPHONE CLIP BRACKET
1996-2007 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, #10, #8
Screwdriver set
T-20 torx bit
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles
computer a false reading, causing a warning light on the instrument cluster. This requires the
vehicles’ computer to be reset with a vehicle diagnostics tool.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use only hardware provided with install kit.
 For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email [email protected] or call 1-
800-524-9900 and ask for technical support.
Police Package Crown Vic Dash. Carefully remove trim panel Remove hex head trim screws
shown above

C-MCB-CV-INST-6-07
2
Slide bracket between trim around
radio and the trim panel
previously removed
Replace screws previously
removed
Re-attach trim panel
Install microphone clip brackets
using #8 x ½” machine screws
and hex nuts
Final assembly