Hay MOUSQUETON User manual

DESIGN BY INGA SEMPÉ
MOUSQUETON
 GENERAL INFORMATION 
TECHNICAL DATA
This product is supplied with an integrated LED
module (2800K warm white, 110 lumens)
The expected lifespan of the LED module is
50,000 hours.
When the light source reaches its end of life, the
whole luminaire should be replaced.
FITTING TYPE | Integrated LED
POWER W | 3.7 W
COLOUR TEMPERATURE | 2800K. Warm White.
∆ Max. charge voltage of battery: 5.8V
∆ Max. charging current: 800mA.
∆ Max. discharge current: 700mA.
ATTENTION
The product must not be modified in any way.
HAY accepts no responsibility for any products
that have been modified or tampered with. The
light source contained in this luminaire should be
exclusively replaced by a qualified electrician in
order to avoid an electrical hazard. If the external
USB charging cable is damaged it should be
replaced immediately. This lamp is designed for
indoor and outdoor use. HAY recommends that
the lamp is not kept outside while raining.
This lamp has an integrated high-performance
lithiumion battery. When charging the battery,
use a USB power source/driver with low voltage
(SELV) output with a constant voltage of 5V, input
current not more than 2A, according to IEC/
EN 61347213. After 300 charging cycles, it will
maintain a capacity of 75% or more. To extend
battery life, it is recommended to regularly charge
it with the supplied USB cable. The battery in this
lamp is non-replaceable. The battery must be
removed from the lamp and disposed of safely
before the lamp is disposed of.
Before removing the battery, make sure that the
lamp is not plugged into a power source. Please
read all instructions before installing the lamp.
NOTE | This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
∆ Reorient or relocate the receiving antenna.
∆ Increase the distance between the
equipment and receiver.
∆ Connect the equipment to an outlet on a
different circuit to the one the receiver is
connected to.
∆ Consult the dealer or an experienced
radio/TV technician for help.
CAUTION | Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment. This device complies with
part 15 of the FCC Rules. Operation is subject to
the following two conditions:
∆ This device may not cause harmful
interference.
∆ This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING | When using outdoor use portable
luminaires, basic safety precautions should always
be followed to reduce the risk of fire, electric
shock and personal injury, including the following:
∆ Use only three-wire outdoor extension cords
that have three-prong grounding plugs
and grounding receptacles that accept the
appliance’s plug.
∆ Ground Fault Circuit Interrupter (GFCI)
protection is to be provided on the circuit(s)
or outlet(s) to be used for the wet location
portable luminaire. Receptacles are
available having built-in GFCI protection
and are able to be used for this measure of
safety.
∆ Use only with an extension cord for outdoor
use, such as an extension cord of cord
type SEW, SEOW, SEOOW, SOW, SOOW, STW,
STOW, STOOW, SJEW, SJEOW, SJEOOW, SJW,
SJOW, SJOOW, SJTW, SJTOW, or SJTOOW.
∆ Suitable for damp and wet locations.
∆ Do not submerge.
CARE AND MAINTENANCE
The product can be cleaned with a soft damp
cloth and mild detergent, or a dry microfibre
cloth. Do not use alcohol or any other solvents
to clean the product and avoid using abrasive or
rough sponges. Ensure that the power supply has
been turned OFF before cleaning the product.
 CARE & MAINTENANCE 
Our Care & Maintenance offers guidance for optimal
maintenance of your HAY product. It includes advice
and instructions on cleaning and caring for specific
materials to prolong the life of your lighting.
Please find our Care & Maintenance
guide by scanning the QR code
You can find more relevant information on
Mousqueton by scanning the QR code
You can also find the same information here
hay.dk/downloads
14102021
Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]
www.hay.com

1.
To charge the battery, insert the USB charger into the USB
port on the bottom of the lampshade and connect the cable
to a power supply. When the battery is charging, the light on
the bottom will show red. When the battery is fully charged,
the light will show green. The lamp can be used while
charging, however this will extend the required charging time
for full capacity.
2.
To turn the lamp on, touch the round button on
the bottom of the lampshade. The lamp has a
three-step dimmable feature. First push sets it
to maximum brightness, second push to medium
brightness and the third push to lowest bright-
ness. Fourth push turns the lamp off.
3.
The carabiner handle can be opened and closed by lifting the
carabiner up and twisting it gently 180 degrees.
Suggestions for use
The carabiner can be used to hang the lamp, to create a cosy
atmosphere in your garden, as shown below.
Suggestions for use
The Mousqueton Portable Lamp can also be balanced
on a stick as shown below..
 PARTS 
Lamp
USB Power Cable
40%
70%
100%
Charging (Red)
Fully charged (Green)