Hay SLANT User manual

– INSTRUCTION MANUAL –
DESIGN BY BRANCH
SLANT

 GENERAL INFORMATION 
TECHNICAL DATA
This product is fitted with an E14 bulb fitting. HAY
recommends using this product with LED bulbs.
FITTING TYPE | LED E27
POWER (W) | 1013W
COLOUR TEMPERATURE | Warm white
HAY will not accept any responsibility for any
accidents, injuries or damages that occur due to
the use of incorrect bulbs.
ATTENTION
Ensure that the power supply to the circuit has
clearly been turned OFF before installing the
product. In some countries, electrical installation
must be carried out by authorised electricians/
contractors; please check with your local
authority for guidance.
The product must not be modified in any way.
HAY accepts no responsibility for any products
that have been modified or tampered with. If the
external flexible cable or cord of this luminaire is
damaged, it should be exclusively replaced by a
qualified electrician in order to avoid an electrical
hazard. This lamp is designed for indoor use only.
CARE AND MAINTENANCE
The product can be cleaned with a soft damp
cloth and mild detergent, or a dry microfibre
cloth. Do not use alcohol or any other solvents
to clean the product and avoid using abrasive or
rough sponges. Ensure that the power supply has
been turned OFF before cleaning the product.

Shade
Diffuser
 PARTS 
Base
Allen key Screws

1.
Unpack all the parts and check that you have received all the parts listed.
Place the diffuser on the base and insert and fasten the supplied screws,
as shown below. The base has a small ridge, with a corresponding groove
on the diffuser, ensuring that the two parts are correctly assembled.

2.
Screw an E27 bulb into the bulb fitting.
It is advised that a dimmable LED bulb, no more than 15W is used in this lamp.
Please note that larger globe-style bulbs will not fit in the lamp.

3.
Place the shade on top of the diffuser, as shown below, aligning the small pin on
the inside of the shade with the corresponding slot on the rim of the diffuser.

4.
Once the shade is in place, it can be secured to the base. Insert the supplied
Allen key into the two holes in the bottom and tighten the two screws that secure
the shade to the base. Take care not to overtighten the screws, as this may dam-
age some of the internal components.

For UK customers, a plug converter will be supplied. If not included, please contact
the HAY retailer from where the lamp was purchased.
Insert the EU plug into the converter provided. Close the converter over the EU
plug with the pins secured in the internal spring clip contacts. Screw the converter
together to ensure the UK plug is secure.
 UK CUSTOMERS ONLY 

 CARE & MAINTENANCE 
Our Care & Maintenance offers guidance for optimal
maintenance of your HAY product. It includes advice
and instructions on cleaning and caring for specific
materials to prolong the life of your lighting.
Please find our Care & Maintenance
guide by scanning the QR code
You can find more relevant information on
Slant by scanning the QR code
You can also find the same information here
hay.dk/downloads

11012022
Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]
www.hay.com