Hay COPENHAGEN DEUX CPH 210 User manual

– INSTRUCTION MANUAL –
DESIGN BY RONAN & ERWAN BOUROULLEC
L75 X W75 X H73 CM
COPENHAGEN DEUX
CPH 210

– INTRODUCTION –
Copenhague Deux is a range of tables and benches for
compact spaces. The collection offers dining tables,
coffee tables and benches in different sizes. The
tabletop surface is made from a new laminate based
on Nanotechnology providing an extremely matt
surface with a soft touch that is anti-fingerprint and
easily cleaned.

CAUTION
With a little care you can prolong the life
of your furniture. Follow the instructions for
the materials of your specific product to
make sure that it stays in the best shape
for as long as possible.
The information below is only intended as
a general guideline. For more information
on how to remove specific stains, please
enquire where you bought the furniture.
/Always remove stains quickly before
they can do any permanent damage to
the furniture.
/Avoid placing the table in direct
sunlight or near a heat source to
reduce changes. As wood is a natural
material, it will change in colour and
will patinate over time.
/When you move your furniture, make
sure you lift it rather than pulling or
pushing it to avoid damaging the floor,
legs and mountings.
/Tighten up the screws after one to two
months’ use and whenever required.
/Avoid improper use such as putting
your feet on the table or standing
on it.
/Use coasters under damp, hot or
coloured objects to avoid permanent
stains.
/Be careful not to scratch or damage
the surface with sharp objects.
/Avoid partially covering the surface,
for example with tablecloths or place
mats, as colour variances may appear.
– CARE AND MAINTENANCE –– CARE AND MAINTENANCE –
LACQUERED OR STAINED WOOD
/Wipe with a clean cloth wrung in water
or in a solution of water and a neutral
detergent. Remove soap residue
immediately using a clean, dry cloth.
/If the surface is scratched or appears
matt, use a care product especially
suited to lacquered or stained wood.
/Avoid using detergents containing
silicone, as they seal the stain in
and make subsequent repairs more
difficult.
/Avoid using scouring cream or
scouring pads, as they may scratch
the surface.
UNTREATED WOOD
/Clean with a clean cloth wrung in
water or in a solution of water and
a neutral detergent or soap flakes.
Remove soap residue immediately
using a clean, dry cloth.
/To remove stains, clean and scrub
using a thick solution of soap flakes
that should not stay on the wood for
more than 2 minutes. Then remove the
remaining soap residue using a damp
cloth.
/If the grain of the wood rises after
cleaning, gently sand down the wood
using fine-grit sandpaper (No. 220),
always going with the grain.
/If the surface is scratched or appears
matt, use a care product especially
suited to untreated wood.
NANOLAMINATE
/Wipe with a clean cloth wrung in water
or in a solution of water and a neutral
detergent or soap flakes. Remove
soap residue immediately using a
clean, dry cloth.
/If the surface is scratched or appears
matt, use a care product especially
suited to linoleum.
/Stains may be carefully removed using
white spirit (mineral spirit) or a damp
nano sponge dipped in lukewarm
water or linoleum care product. Follow
up immediately with a clean, dry cloth.
Never use the nano sponge dry.
/Avoid alkaline detergents such as soft
(yellow soap, washing soda, lye and
scouring powder.
/Avoid using scouring cream or
scouring pads, as they may scratch
the surface.

– PARTS –
1.
While assembling, keep the table inside the cardboard box with
foam edge in order to protect the tabletop from scratches etc.
Make sure that all parts are included.

C x 20
Allen key

A x 1

B x 4

2.
Place the

B parts on the reverse side of

A and align them with the holes.
Insert the

C parts into the holes and gently tighten them.
3.
Use the Allen key to tighten the

C parts completely.

4.
Turn the table over.
5.

Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]
01/07/2020