> CARE AND MAINTENANCE <
When you move the table, make sure to lift it rather than
pulling or pushing it, as that would damage the legs
and mountings. We recommend that you tighten up the
screws and nuts after one to two months’ use. Avoid
improper use such as putting your feet on the table and
standing on it. Wood and linoleum are natural materials,
which may change in colour and will patinate over time.
To reduce changes avoid placing the table in direct
sunlight or near a heat source. To avoid permanent
stains, use coasters under damp, hot or coloured
objects. We recommend that you avoid covering the
surface partially, for example with tablecloths or place
mats, as colour variances may appear. Always remove
stains quickly before they can do any permanent
damage to the tabletop.
CLEANING
Lacquered or painted wood / For daily maintenance, wipe
the surface with a clean, dry cloth. For cleaning, use
a clean cloth wrung in water or in a solution of water
and a neutral detergent (soap flakes) or a care product
suited especially for lacquered or painted wood. Remove
soap residue immediately using a clean, dry cloth. To
remove stains, use a clean, damp cloth wrung in luke-
warm water with one part vinegar to nine parts water.
Follow up immediately with a clean dry cloth. If the
surface is scratched or appears matt, use lacquer care.
Avoid using detergents containing silicone, as that would
seal the stain in and make subsequent repairs more
difficult. Avoid using scouring cream or scouring pads,
as they may scratch the surface.
Untreated wood / For daily maintenance, wipe the wood
with a clean, dry cloth. For cleaning, use a clean cloth
wrung in water or in a solution of water and a neutral
detergent (soap flakes) or a care product suited
especially for untreated wood. Remove soap residue
immediately using a clean, dry cloth. To remove stains,
clean and scrub using a thick solution of soap flakes
that is not allowed to stay on the wood for more than 2
minutes. Then remove the remaining soap residue using
a damp cloth. If the grain of the wood rises after clean-
ing, gently sand down the wood using fine-grit sand-
paper (No. 220), always going with the grain.
Nanolaminate / Clean the tabletop with a clean cloth
wrung in a solution of water and a universal detergent.
Soap residue and excess moisture should be removed
immediately, using a clean, dry cloth. Stains and small
scratches can be removed gently with a clean, damp
cloth or a nano-sponge wrung in warm water. Never
use the nano sponge dry. Follow up immediately with
a clean, dry cloth. Avoid using abrasive products when
cleaning nano-laminate, as they may scratch the surface.
