CAUTION
With a little care you can prolong the life of your
furniture. Follow the instructions for the materials of
your specific product to make sure that it stays in
the best shape for as long as possible.
The information below is only intended as a
general guideline. For more information on how
to remove specific stains, please enquire where
you bought the furniture.
• Always remove stains quickly before they can do
any permanent damage to the furniture.
• Avoid placing the table in direct sunlight or near a
heat source to reduce changes. As wood is a natural
material, it will change in colour and will patinate
over time.
• When you move your furniture, make sure you lift it
rather than pulling or pushing it to avoid damaging
the floor, legs and mountings.
• Tighten up the screws after one to two months’ use.
• Avoid improper use such as putting your feet on
the table and standing on it.
• Use coasters under damp, hot or coloured objects
to avoid permanent stains.
• Avoid partially covering the surface, for example
with tablecloths or place mats, as colour variances
may appear.
• Be careful not to scratch or damage the surface
with sharp objects.
CARE AND MAINTENANCE CARE AND MAINTENANCE
LACQUERED OR STAINED WOOD
• Wipe with a clean cloth wrung in water or in a
solution of water and a neutral detergent. Remove
soap residue immediately using a clean, dry cloth.
• If the surface is scratched or appears matt, use
a care product especially suited to lacquered or
stained wood.
• Avoid using detergents containing silicone, as
they seal the stain in and make subsequent
repairs more difficult.
• Avoid using scouring cream or scouring pads,
as they may scratch the surface.
UNTREATED WOOD
• Clean with a clean cloth wrung in water or in a
solution of water and a neutral detergent or soap
flakes. Remove soap residue immediately using a
clean, dry cloth.
• To remove stains, clean and scrub using a thick
solution of soap flakes that should not stay on the
wood for more than 2 minutes. Then remove the
remaining soap residue using a damp cloth.
• If the grain of the wood rises after cleaning, gently
sand down the wood using fine-grit sandpaper (No.
220), always going with the grain.
• If the surface is scratched or appears matt, use a
care product especially suited to untreated wood.
NANOLAMINATE
• Wipe with a clean cloth wrung in water or in a
solution of water and a neutral detergent. Remove
soap residue immediately using a clean, dry cloth.
• Stains may be carefully removed using household
ammonia or with a clean, damp cloth or a nano sponge
wrung in warm water. Never use the nano sponge dry.
Follow up immediately with a clean, dry cloth.
• Avoid using scouring cream or scouring pads,
as they may scratch the surface.
• If the surface is scratched or appears matt, use
a care product especially suited to linoleum.
