HB-THERM M8124-EN User manual

Temperatur Control Technology
www.hb-therm.ch
M8124-EN 2018-03 1/3
2018-03
Page
Assembly Instructions
M8124-EN
Spare part light bulb complete (O/ID T26415)
Purpose
Replacement of light bulb complete (HL 1.x)
Precondition
WARNING!
Danger for unauthorized persons!
Conversion work may only be carried out by
specialist staff who have been trained accordingly.
Therefore:
–Keep unauthorized persons away from the work
area.
NOTE!
Knowledge of the Instruction Manual is a
precondition for carrying outconversion work on the
unit.
Procedure
DANGER!
Danger to life caused by electric current!
Touching conductive parts causes a direct danger
to life.
Therefore:
–For all work on the electrical system, for
maintenance, cleaning or repair work,
disconnect from the mains or disconnect all
phases of the external power supply and secure
them against being switched on again. Check
unit is isolated from power supply.
WARNING!
Danger of crushing due to rolling away or
tipping
With an uneven floor or when the castors are not
locked, there is a danger that the unit tips over or
rolls away causing crushing.
Therefore:
–Only install the unit on an even floor.
–Ensure that the castors are locked.

Assembly Instructions M8124-EN
M8124-EN 2018-03 2/3
1. Proceed as follows in order to cool down the unit and empty
the mould (mould evacuation)
Display menu page Functions.
Select the function Cooling and activate with the key.
Select the function Mould evacuation and activate with the
key.
The activated function is indicated with the symbol.
2. Main switch off, remove the plug from the mains and empty
the unit.
Fig. 1 Flow-5, autonom. module
Fig. 2: Connection of light bulb (HL 1.x) to
8 pin cable plug.
3. Replace light bulb (HL 1.x)at measuring circuit x while
proceeding as follows:
Disconnect the cable plug from the socket (X 402.x)Fig. 1) at
the evaluation unit.
Disconnect screws (Label 1 Fig. 1) and remove cover.
Detach the light bulb (Fig. 1).
Open the 8 pin cable plug and replace the light bulb (HL 1.x)
with a new one (connect cable plug Fig. 2).
Close 8 pin cable plug and connect it to the socket
(X 402.x Fig. 1).
Connect new light bulb (HL 1.x Fig. 1).
Mount cover with screws (Label 1 Fig. 1).
4. Reconnect mains plug and switch on main switch.
5. Switch the unit on with the key.
6. Check unit functions.
7. Switch the unit off by press the key.
8. Main switch off.
HL 1.x
1
X 402.x

Assembly Instructions M8124-EN
M8124-EN 2018-03 3/3
Parts list
Pos
Description
O/ID
Pcs
01
Light bulb complete
T26332
1
02
Assembly instructions German
M8124-DE
1
03
Assembly instructions English
M8124-EN
1
04
Assembly instructions French
M8124-FR
1