Heart of House 3045495 User manual

STONE TOILET ROLL HOLDER
Assembly Instructions – Please keep for future reference 304/5495
Dimensions
Base – Dia.147mm/T.22mm
Pole – Dia.16 mm/400mm
Height – 417mm
Important – Please read these instructions fully before starting assembly
If you need hel or have damaged or missing arts, call the Customer Helpline:
Argos = 0345 640 0800
Issue 1 – 15/11/2014

Safety and Care Advice
Important– Please read these instructions fully before starting assembly
 Check you have all the components and
tools listed on the following pages.
 Remove all fittings from the plastic bags
and separate them into their groups.
 Keep children and animals away from the
work area, small parts could choke if
swallowed.
 Make sure you have enough space to
layout the parts before starting.
 During assembly do not stand or put
weight on the product, this could cause
damage.
 Assemble the item as close to its final
position in the same room) as possible.
 Assemble on a soft level surface to avoid
damaging the unit or your table.
 Parts of the assembly could be done with
1 person.
Care and maintenance
 Only clean using a dam cloth and
mild detergent, do not use bleach or
abrasive cleaners.
 From time to time check that there are
no loose screws on this unit.
 This roduct should not be discarded
with household waste. Take to your
local authority waste dis osal centre.
Handy Hints
 Assemble all arts and bolts loosely
during assembly once the roduct is
com lete should you fully tighten the
bolts.
 Regularly check and ensure that all
bolts and fittings are tightened
ro erly.

Components - Parts
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 640 0800
Please check you ha e all the components listed below
□
1
Metal Pole
□
2
Base
16 D) x 400 T)mm 147 D) x 22 T)mm
Components - Fittings
Please check you ha e all the components listed below
Note: The bolts and metal washer are pre-assembled on the metal pole for transit. To remove it, please loosen
the bolts and metal washer for assembling the product. The quantities below are the correct amount to complete
the assembly. In some cases more fittings may be supplied than are required.
○
A Bolt x 1
○
B Metal washer x 1
Tools required
Screwdriver

Assembly Instru tions
Step 1
Attach Metal ole □ 1
with base □ 2 using
Bolt ○ A + Washer ○ B
tighten with each other.
Assembly is com lete.
If you need hel or have damaged or missing arts, call the Customer Helpline:
Argos = 0345 640 0800