Heart of House Rattan chair with seat pad 339/8324 User manual

rattan chairs with seat pad
Dimensions
Width - 46cm
Depth - 56cm
Height - 104cm
Issue 1 - 30/10/14
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400800
Assembly Instructions - Please keep for future reference
319/5558
339/8324

1
Safety and Care Advice
Important – Please read these instructions fully beforestarting assembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Check you have all the
components and tools listed on
the following pages
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
•Assemble the item as close
to its final position (in the same
room) as possible.
•Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly may be
easier with 2 people.
• To reduce the
likely hood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
•This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
•Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Reguraly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints
•Assemble the item as close
to its final position (in the
same room) as possible.
• The maximum safe weight of
user: 110 kgs.
• Do not stand on this chair.
• Do not use this chair as a step
ladder.

Components
Please check you have all the panels listed below
2
Back frame (42 x104cm)
1
If you have damaged or missing components,
call the Customer Helpline:
0345 6400800
Seat frame (46 x41cm)
2
Leg x 2
(4x43cm)
3Cushion (46x39cm) 4

3
Please check you have all the fittings listed below
Ruler - Use this ruler to help correctly identify the screws
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
Components - Fittings
Medium bolt M6x50mm x 4 Length bolt M6x70mm x 4 Short bolt M6x35mm x 2
Spring washer Ø11 x 10 Flat washer Ø16 x 10 Allen key
A
D
B
C
E
F
The Bolts length is measured from the head to the point ( 35mm bolts shown).

4
Assembly Instructions
Step 1
Put all parts on a soft
surface to prevent
scratches.
Open dust cover of
seat frame 2
.
.
Attach seat frame 2 to
back frame 1 by long
bolts , short bolt ,
spring washer , flat
washer ,Using allen
key , partially tighten
the bolts as shown,
2
F
B C
D
E
2
1
Step 2

5
Assembly Instructions
Attach legs 3 to seat frame
2 by medium bolts ,
spring washer , flat
washer . Using allen key
, full tighten all the bolts
as shown.
L
Step 4
Step 3
A
D
E
F
Close the dust cover of
seat frame then stick it
on the twon side- stretcher
rails.

Assembly Instructions
Step 5
Put a cushion 4 on top
seat frame 2 then stick
at back of chair as shown.
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400800
Step 6
Assembly is complete.