Case Ballet Installation guide

Ballet
Bench 1.9m
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
casefurniture.com
Ballet Bench 1.9m – designed by Matthew Hilton
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This unit is manufactured from solid oak.
Craftsmen manufacture this product and there is variety between each unit. This is
because wood is a natural product, with natural colour and grain variations.
Natural timber is affected by sunlight; this can can the wood colour to darken.
For this reason (especially if placed in direct sunlight) it is recommended that placing
objects in the same position for long periods of time is avoided. This potential colour
adjustment becomes less relevent as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit.
Please only use proprietary furniture polishes or alternatively, warm water with
a diluted mild detergent.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com

Assembly Instructions
A x 5
C x 9
Required
Supplied
D x 4
E x 2
F x 2
Step 1. Screw in (tting F) and tighten with a
screwdriver into the to the top hole on the
legs and place the dowels (tting D) into the
2 bottom holes on both legs.
Step 2. Place (tting E) into the hole at the
end of the cross rail, once in place align
with the holes on the leg and tighten (tting
D).
Step 3. Place the 5 washers (tting C) and bolts
(tting A) into the holes on the cross rail and 4
washers (tting C) and bolts (tting B) into the
holes in the legs.
Make sure all the bolts are properly aligned, then
use the supplied Alan key that has been provided
to tighten all the bolts. Carefully turn the bench
over.
Step 1.
Step 2.
Step 3.
B x 4