heightec RescuePack WK32 User manual

with respect to gravity...
®
TM
The heightec Group Ltd, Lake District Business Park, Mint Bridge Road, Kendal, LA9 6NH
T: [phone] F:[phone]
REF: UI WK32 Issued: 07/04/11 Revised: 05/12/14 Approved:CE
User Instructions
ONLY FOR USE BY COMPETENT PERSONS, WHO HAVE BEEN
TRAINED ON THIS SPECIFIC KIT.
THESE UI ARE TO BE READ IN CONJUNCTION WITH UI FOR
EACH ITEM OF THE KIT.
LOWERING
(see overleaf for raising)
1. Select an unquestionably sound anchorage
structure, above casualty.
2.Pass anchor strop (A) around anchorage and
connect karabiner to screwlink.
3.Fit open hook to end of pole. With control-
device half-threaded, extend pole to casualty
(B). Attach hook to harness and pull to release,
ensuring hook gate closes fully.
4.Pull rope to casualty tight by pulling tail end
through device (C).
5. Fully thread control-device & lock-off by
passing tail rope loop through the screwlink then
around device (D).
6.Check all connections, then cut casualty’s fall
arrest lanyard, with knife.
7. Gently lower casualty by holding tail rope and
squeezing device handle into ‘sweet spot’ (E).
A
B
C
DE
WK32 - RescuePack™

with respect to gravity...
®
TM
The heightec Group Ltd, Lake District Business Park, Mint Bridge Road, Kendal, LA9 6NH
T: [phone] F:[phone]
REF: UI WK32 Issued: 07/04/11 Revised: 05/12/14 Approved:CE
A
B
D
C
E
ONLY FOR USE BY COMPETENT PERSONS, WHO HAVE BEEN
TRAINED ON THIS SPECIFIC KIT.
THESE UI ARE TO BE READ IN CONJUNCTION WITH UI FOR
EACH ITEM OF THE KIT.
RAISING
(see overleaf for lowering)
1. Select an unquestionably sound anchorage
structure, above casualty.
2.Pass anchor strop (A) around anchorage and
connect karabiner to screwlink.
3.Fit open hook to end of pole. With control-
device half-threaded, extend pole to casualty
(B). Attach hook to harness and pull to release,
ensuring hook gate closes fully.
4.Pull rope to casualty tight by pulling tail end
through device (C).
5. Attach hauling-device to casualty rope and
thread tail rope through pulley as shown (D).
DO NOT PUT DEVICE OVER EDGE
6.To raise casualty, pull tail rope (E).
7. When hauling-device reaches control-device,
slide hauling-device back down rope.
8. Repeat steps 6 & 7 to incrementally raise
casualty as required.
User Instructions
WK32 - RescuePack™