HEPRO Aktiv G1 User manual

Work Chairs
Operating Instructions
HEPRO AS •
Tlf. [phone] •
www.hepro.no
Hepro Aktiv work chair
Model G1- and G2 Aktiv
Please read this operating instruction carefully!
Tested and in conformance with the following norms and guidelines:
EN 12182
EN 1021 –1
EN 1335-1, 2, 3
EN 1021 –2
EN ISO 14971

Work Chairs
Operating Instructions
HEPRO AS •
Tlf. [phone] •
www.hepro.no
Intended use
Hepro Aktiv work chair is designed to help people with disabilities that make it difficult for
them to execute an activity in an upright position, and at the same time have problem with
movement during the activity. The chair has big levers with clear symbols and can be easily
adjusted to fit ergonomically while simultaneously taking into account the body's
movements. It offers good legroom and is easy to move, but is
stable when the brake is activated
Assembling and adjusting the backrest
The chair is delivered without the backrest assembled. To
assemble it, place it gently on the post till it stops. Open the
clamp for the height regulation on the right side. Press the
backrest all the way down. Then use the same clamp to open
and regulate to desired position.
Adjusting the armrest
Armrest pad can easily be pushed forward or back.
The height is regulated by holding up the outer mantle and
then move the armrest to desired position.
The whole armrest can be folded back by pressing the plastic
latch at the bottom.

Work Chairs
Operating Instructions
HEPRO AS •
Tlf. [phone] •
www.hepro.no
Regulations
By lifting the lever 1 the gas spring is triggered and the seat can be raised or lowered.
Lever 2 opens the seat slider and the seat can be moved forward or back.
Lever 3 has two functions. Turn back and the backrest
angle can be changed. Turn ahead 90 ⁰ and the whole
seat unit is disengaged and can be desiredly adjusted.
For models with seat rotation lever 4 is turned to open
or lock the rotation. It can be locked at every 90 ⁰.
The wheel brake is activated by pushing the brake
handle forward. Then both rotation and swivel are
locked, and the chair remains perfectly still.
Regulating the brake handle
The brake handle can be moved sideways by loosening
the two Unbraco screws holding the handle. The
handle can also be moved to the other side. The
position is locked by tightening the screws. Use the
2,5mm Unbraco key supplied with the chair. (It is
located on the right side in the center of the wheel
base).
1
4
2
3

Work Chairs
Operating Instructions
HEPRO AS •
Tlf. [phone] •
www.hepro.no
Cleaning
The fabric can be washed in water up to 60°C or cleaned with foam cleaner.
All parts of frame and chassis can be cleaned with a damp cloth and mild soap.
Warranty
When used in accordance with the Operating Instructions HEPRO provides a 2-year warranty
against defects in material and workmanship.
Please address warranty complaints or other inquiries about the product to your supplier or
importer. Always state the product`s serial number as a reference.
Safety Provisions
The chair is an aid, and shall not be used as «a toy» for children.
Exceeding approved user weight (150 kg) may cause damage to both user and product.
Do not stand on the foot ring! The chair will probably overturn!
Although the fabric is flame retardant it must not be exposed to naked flame, cigarette
embers or the like.