hernest H200020 User manual

USER MANUAL
1
Caution
Please consu lt the professionals before installation or repairing. The company takes no liabilities for any damage or
injuries that occur during the installation of the pipes, floor, wall and tub.
Thank you for shopping with Hernest, please read this user manual thoroughly for your full under-
standing, installing, and application of the product. Please have this user manual well-reserved
for future reference.
Before Installation
Check the package and ensure that all parts are included. If any part is missing or damaged, please contact us.
Do not disassemble the main body, as it has been installed & commissioned correctly & precisely before leaving
the factory.
Shut off the main water supply before the installation.
Do flush the water supply lines to remove any dirt and debris before installation(IMPORTANT).
Make sure to connect the hot/cold inlet pipe correctly. If standing in front, usually the hot water pipe connects to
the left and the cold water pipe to the right.
Check for leaks and make sure every joint is safely sealed after the installation,
Turn on the water supply and flush the water pipes for 3 minutes to make sure it works well before putting it
into use.
SKU:H200020
Two Handle Widespread Bathroom Faucet

2
3Maximum thickness for sink or counter-
top is 13/16'' or 30mm 4Handle with the hot label should be
installed in the left hole
2.8”
Max 30mm(1.2”)
Hot COLD
a b
Note
1The inlet pipe must not be overly bent 2The inlet pipe must not be overly twisted
Tools you will need
Pex. Water hose ×2
Read install information refer to Components List thoroughly for part names
Plastic backing Handle lock nuts
Gasket
(Rubber gasket a,
stainless steel gasket b)
Instructions

3
Installation Steps
3Connect inlet hoses① with faucet body
and mixer water pipe② with spout.
Connect both inlet hoses to hot and cold
water supplies. Test after screwing tight
all connections.
1 2
please flush the water pipe for at least 2
minutes before installation to ensure
that no impurities interferes, and
supplies hot and cold water from angle
valve.
put faucet body and spout through
reserved holes, adjust direction of faucet
and spout. Install spout lock screw③
and gasket④ to faucet and screw tight.
Gasket a first, b second.
4Try the product’s functionality and
finish.
Hot COLD

4
www.hernest.com
For more detail information, please check out www.hernest.com
It will be our pleasure to have your visit.
After-Sale Service
If you have any issues with the product, please feel free to contact us online or by phone for customer service.
Phone No.: [phone]
Service E-mail: [email protected]