HIK VISION DS-K1200 Series Instruction Manual

Title:
DS-K1200 Series Card Readers Connect
to DS-K2600 Series Access Controllers
Version:
v1.0
Date:
6/21/2017
Product:
Access Control Device
Page:
1 of 3
DS-K1200 Series Card Readers Connect to DS-K2600
Series Access Controllers
Preparation
Connecting card reader to access controll is mainly applied to swiping card or fingerprints to open the
door for entering and exiting. The models of card reader and access controller in this guide are as below:
Card Reader
Access Controller
DS-K1200MF
DS-K2601,
DS-K2602,
DS-K2604
DS-K1200EF
Notice
1. Please cut off power supply before wiring;
2. DS-K1200 Series Fingerprint Card Readers support private RS485 protocol; the details about RS-485
interface of fingerprint card reader are as below:
3. Correspondingly, there are RS485 interfaces in DS-K2600 series access controllers; you can find RS-
485 interface at the same position in DS-K2601/02/04 access controllers, as pictures show:
4. Please check the rear panel of card reader and unscrew it, you could find DIP switch module;
The No. of DIP switch from left to right is 1~4:
Color
Description
Blue
RS-485 -
Yellow
RS-485 +
Red
PWR (DC +12V)
Black
GND (Power Grounding)
Black
GND (RS-485 Grounding)
Icon
Description
Represent 1 in binary mode
Represent 0 in binary mode

Title:
DS-K1200 Series Card Readers Connect
to DS-K2600 Series Access Controllers
Version:
v1.0
Date:
6/21/2017
Product:
Access Control Device
Page:
2 of 3
For example, the binary value of the above status is 0011.
Step 1: DIP Switch
Please set the DIP switch firstly before connecting the card reader, more details about the binary value of
the card reader by setting DIP Switch to correspond with the door, please check the table below:
DIP Switch Status
Door
Reader
1000
Door 1
Entrance Reader 1
0100
Eixt Reader 2
1100
Door 2
Entrance Reader 3
0010
Eixt Reader 4
1010
Door 3
Entrance Reader 5
0110
Eixt Reader 6
1110
Door 4
Entrance Reader 7
0001
Eixt Reader 8
Step 2: RS-485 Wiring
Please connect card reader to door station as following picture:
Note
1. Actually you can find RS485 A/B/C/D interfaces in access controller; we extend RS485 A interface
to the wiring distribution for easier cable connection and we use RS485B interface for backup, the
cable connection as following picture:
2. About wiring materials, we suggest customer choose RVVP cable.
RS485-
RS485+
Power GND
+12V
RS485 GND
RS485 A+
RS485 A-
RS485 B+
RS485 B-

Title:
DS-K1200 Series Card Readers Connect
to DS-K2600 Series Access Controllers
Version:
v1.0
Date:
6/21/2017
Product:
Access Control Device
Page:
3 of 3
First Choice for Security Professionals
HIKVISION Technical Support