
HOW TO SET UP YOUR GATEWAY:
Follow these steps to connect your new gateway, the all-in-one device that
allows you to utilize both wired and wireless (WiFi) devices.
Locate cable wall outlet (coaxial) in a central location. It will look like this:
1
2
3
4
Connect coaxial cable from the wall to gateway (insert into connector and turn barrel to tighten).
Connect power cord from gateway to the wall outlet . The gateway will update once powered
on, which could last around 10 minutes. Once lights are glowing steady, it’s ready to use.
If you’re connecting a wired device, use the Ethernet cord provided to connect the gateway to
the back of the device .
Note: If you’re connecting Atlantic Broadband phone service, use the phone cord to connect your phone to the gateway . If you
have more than one phone, or devices that use a phone line (i.e. credit card machine, fax machine, etc.), you will need to plug the
phone line from the modem into an unused phone jack on the premises to feed dial tone for all devices.
131475 ABC190 Hiltron.indd 6131475 ABC190 Hiltron.indd 6 5/5/20 2:33 PM5/5/20 2:33 PM